lkml.org 
[lkml]   [2014]   [Jul]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v2 1/2] clk: samsung: exynos4: Enable ARMCLK down feature
From
Date
On śro, 2014-07-23 at 17:18 -0700, Mike Turquette wrote:
> Quoting Krzysztof Kozlowski (2014-07-18 07:36:32)
> > Enable ARMCLK down feature on all Exynos4 SoCs. The frequency of
> > ARMCLK will be reduced upon entering idle mode (WFI or WFE).
> >
> > The feature behaves like very fast cpufreq ondemand governor. In idle
> > mode this reduces energy consumption on full frequency chosen by
> > cpufreq governor by approximately:
> > - Trats2: 6.5% (153 mA -> 143 mA)
> > - Trats: 33.0% (180 mA -> 120 mA)
> > - Gear1: 27.0% (180 mA -> 130 mA)
>
> Nice power savings! Just a quick question on this feature: the clock
> frequency is changed in hardware as a result of WFI/WFE?

Yes. This feature makes changes in DIVCORE and DIVCORE2 clock dividers
when given core enters WFI/WFE.

> And this only
> happens when all CPUs in a cluster (e.g. all 4 CPUs in Exynos 4412) are
> in WFI/WFE state?

No, this is per-core. However measured energy savings above were in case
where all cores entered idle (WFI).

Best regards,
Krzysztof


>
> Thanks,
> Mike
>
> >
> > The patch uses simillar settings as Exynos5250 (clk-exynos5250.c),
> > except it disables clock up feature and on Exynos4412 ARMCLK down is
> > enabled for all 4 cores.
> >
> > Tested on Trats board (Exynos4210), Trats2 board (Exynos4412) and
> > Samsung Gear 1 (Exynos4212).
> >
> > Signed-off-by: Krzysztof Kozlowski <k.kozlowski@samsung.com>
> >
> > ---
> >
> > Changes since v1:
> > 1. Add PWR_CTRL registers to the list of saved clk registers on
> > Exynos4x12. Suggested by Tomasz Figa.
> > 2. Disable the clock up feature. (sug. Tomasz Figa)
> > 3. Use macros for setting clock down ratio. (sug. Tomasz Figa)
> > 4. Use num_possible_cpus() for exception on Exynos4x12. (sug. Tomasz
> > Figa)
> > 5. Enable the clock down feature also on Exynos4210 Trats board.
> > ---
> > drivers/clk/samsung/clk-exynos4.c | 46 +++++++++++++++++++++++++++++++++++++++
> > 1 file changed, 46 insertions(+)
> >
> > diff --git a/drivers/clk/samsung/clk-exynos4.c b/drivers/clk/samsung/clk-exynos4.c
> > index 7f4a473a7ad7..86c7709dc6d6 100644
> > --- a/drivers/clk/samsung/clk-exynos4.c
> > +++ b/drivers/clk/samsung/clk-exynos4.c
> > @@ -114,11 +114,27 @@
> > #define DIV_CPU1 0x14504
> > #define GATE_SCLK_CPU 0x14800
> > #define GATE_IP_CPU 0x14900
> > +#define PWR_CTRL1 0x15020
> > +#define E4X12_PWR_CTRL2 0x15024
> > #define E4X12_DIV_ISP0 0x18300
> > #define E4X12_DIV_ISP1 0x18304
> > #define E4X12_GATE_ISP0 0x18800
> > #define E4X12_GATE_ISP1 0x18804
> >
> > +/* Below definitions are used for PWR_CTRL settings */
> > +#define PWR_CTRL1_CORE2_DOWN_RATIO(x) (((x) & 0x7) << 28)
> > +#define PWR_CTRL1_CORE1_DOWN_RATIO(x) (((x) & 0x7) << 16)
> > +#define PWR_CTRL1_DIV2_DOWN_EN (1 << 9)
> > +#define PWR_CTRL1_DIV1_DOWN_EN (1 << 8)
> > +#define PWR_CTRL1_USE_CORE3_WFE (1 << 7)
> > +#define PWR_CTRL1_USE_CORE2_WFE (1 << 6)
> > +#define PWR_CTRL1_USE_CORE1_WFE (1 << 5)
> > +#define PWR_CTRL1_USE_CORE0_WFE (1 << 4)
> > +#define PWR_CTRL1_USE_CORE3_WFI (1 << 3)
> > +#define PWR_CTRL1_USE_CORE2_WFI (1 << 2)
> > +#define PWR_CTRL1_USE_CORE1_WFI (1 << 1)
> > +#define PWR_CTRL1_USE_CORE0_WFI (1 << 0)
> > +
> > /* the exynos4 soc type */
> > enum exynos4_soc {
> > EXYNOS4210,
> > @@ -155,6 +171,7 @@ static unsigned long exynos4210_clk_save[] __initdata = {
> > E4210_GATE_IP_LCD1,
> > E4210_GATE_IP_PERIR,
> > E4210_MPLL_CON0,
> > + PWR_CTRL1,
> > };
> >
> > static unsigned long exynos4x12_clk_save[] __initdata = {
> > @@ -164,6 +181,8 @@ static unsigned long exynos4x12_clk_save[] __initdata = {
> > E4X12_DIV_ISP,
> > E4X12_DIV_CAM1,
> > E4X12_MPLL_CON0,
> > + PWR_CTRL1,
> > + E4X12_PWR_CTRL2,
> > };
> >
> > static unsigned long exynos4_clk_pll_regs[] __initdata = {
> > @@ -1164,6 +1183,32 @@ static struct samsung_pll_clock exynos4x12_plls[nr_plls] __initdata = {
> > VPLL_LOCK, VPLL_CON0, NULL),
> > };
> >
> > +static void __init exynos4_core_down_clock(enum exynos4_soc soc)
> > +{
> > + unsigned int tmp;
> > +
> > + /*
> > + * Enable arm clock down (in idle) and set arm divider
> > + * ratios in WFI/WFE state.
> > + */
> > + tmp = (PWR_CTRL1_CORE2_DOWN_RATIO(7) | PWR_CTRL1_CORE1_DOWN_RATIO(7) |
> > + PWR_CTRL1_DIV2_DOWN_EN | PWR_CTRL1_DIV1_DOWN_EN |
> > + PWR_CTRL1_USE_CORE1_WFE | PWR_CTRL1_USE_CORE0_WFE |
> > + PWR_CTRL1_USE_CORE1_WFI | PWR_CTRL1_USE_CORE0_WFI);
> > + /* On Exynos4412 enable it also on core 2 and 3 */
> > + if (num_possible_cpus() == 4)
> > + tmp |= PWR_CTRL1_USE_CORE3_WFE | PWR_CTRL1_USE_CORE2_WFE |
> > + PWR_CTRL1_USE_CORE3_WFI | PWR_CTRL1_USE_CORE2_WFI;
> > + __raw_writel(tmp, reg_base + PWR_CTRL1);
> > +
> > + /*
> > + * Disable the clock up feature on Exynos4x12, in case it was
> > + * enabled by bootloader.
> > + */
> > + if (exynos4_soc == EXYNOS4X12)
> > + __raw_writel(0x0, reg_base + E4X12_PWR_CTRL2);
> > +}
> > +
> > /* register exynos4 clocks */
> > static void __init exynos4_clk_init(struct device_node *np,
> > enum exynos4_soc soc)
> > @@ -1250,6 +1295,7 @@ static void __init exynos4_clk_init(struct device_node *np,
> > samsung_clk_register_alias(ctx, exynos4_aliases,
> > ARRAY_SIZE(exynos4_aliases));
> >
> > + exynos4_core_down_clock(soc);
> > exynos4_clk_sleep_init();
> >
> > pr_info("%s clocks: sclk_apll = %ld, sclk_mpll = %ld\n"
> > --
> > 1.9.1
> >

--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2014-07-24 09:23    [W:0.058 / U:0.268 seconds]
©2003-2017 Jasper Spaans. hosted at Digital OceanAdvertise on this site