lkml.org 
[lkml]   [2014]   [Jul]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH V2] ARM: dts: Restructure imx6qdl-wandboard.dtsi for new rev C1 board.
On Tue, Jul 08, 2014 at 12:48:16PM -0600, George Joseph wrote:
> The rev C1 Wandboard uses the Broadcom 4330 for WiFi and Bluetooth instead of
> the 4329. This changes the PADS assigned for the control lines. Another
> side effect of the change is that on the rev C1 board, usdhc driver can't
> detect the chip presence correctly so usdhc2 now needs its 'non-removeable'
> property removed.
>
> So that rev B1 and earlier can continue to work, this patch splits the
> board-specific definitions from imx6qdl-wandboard.dtsi into
> imx6qdl-wandboard-revb1.dtsi and imx6qdl-wandboard-revc1.dtsi. The new files
> include the original base imx6qdl-wandboard.dtsi which retains the common
> definitions.
>
> The existing imx6dl-wandboard.dts includes imx6qdl-wandboard-revc1.dtsi and
> imx6dl-wandboard-revb1.dts (new) includes imx6qdl-wandboard-revb1.dtsi.
> This makes the rev C1 board the new default. The same pattern is used for
> imx6q-wandboard.dts.
>
> So, from U-Boot on a WB-Quad you use imxq-wandboard-revb1.dtb for the older B1
> board and imxq-wandboard.dtb for the current rev C1 board.
>
> Signed-off-by: George Joseph <george.joseph@fairview5.com>
> ---
> arch/arm/boot/dts/imx6dl-wandboard-revb1.dts | 22 ++++++++++++++
> arch/arm/boot/dts/imx6dl-wandboard.dts | 2 +-
> arch/arm/boot/dts/imx6q-wandboard-revb1.dts | 26 ++++++++++++++++
> arch/arm/boot/dts/imx6q-wandboard.dts | 2 +-
> arch/arm/boot/dts/imx6qdl-wandboard-revb1.dtsi | 42 ++++++++++++++++++++++++++
> arch/arm/boot/dts/imx6qdl-wandboard-revc1.dtsi | 41 +++++++++++++++++++++++++
> arch/arm/boot/dts/imx6qdl-wandboard.dtsi | 21 -------------
> 7 files changed, 133 insertions(+), 23 deletions(-)
> create mode 100644 arch/arm/boot/dts/imx6dl-wandboard-revb1.dts
> create mode 100644 arch/arm/boot/dts/imx6q-wandboard-revb1.dts

These two should be added into arch/arm/boot/dts/Makefile as build
target.

I fixed it up and applied the patch.

Shawn


\
 
 \ /
  Last update: 2014-07-10 09:41    [W:0.051 / U:0.108 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site