Messages in this thread | | | Date | Thu, 26 Jun 2014 00:42:09 -0700 | From | Tony Lindgren <> | Subject | Re: [PATCH V4 00/16] irqchip: crossbar: Driver fixes |
| |
* Sricharan R <r.sricharan@ti.com> [140626 00:14]: > This series does some cleanups, fixes for handling two interrupts > getting mapped twice to same crossbar and provides support for > hardwired IRQ and crossbar definitions. > > On certain platforms such as DRA7, SPIs 0, 1, 2, 3, 5, 6, 10, > 131, 132, 133 are direct wired to hardware blocks bypassing > crossbar. This quirky implementation is *NOT* supposed to be the > expectation of crossbar hardware usage. This series adds support > to represent such hard-wired irqs through DT and avoid generic > allocation/programming of crossbar in the driver. > > This way of supporting hard-wired irqs was a result of > the below discussions. > http://www.spinics.net/lists/arm-kernel/msg329946.html > > Based on 3.16 rc2 mainline.
Jason, once these patches look OK for merging, can you please set them up into an immutable branch so I too can merge them in?
The immutable branch is needed so I can eventually apply the related .dts changes to enable the crossbar interrupts.
Regards,
Tony
| |