lkml.org 
[lkml]   [2014]   [Jun]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [RFC 0/5] of: Automatic console registration cleanups
On Fri, Mar 28, 2014 at 11:08 AM, Grant Likely <grant.likely@linaro.org> wrote:
> Hi all,
>
> This is a series that I've been playing with over the last few days to
> clean up the selection of default console devices when using the device
> tree. The device tree defines a way of specifying the console by using a
> "stdout-path" property in the /chosen node, but very few drivers
> actually attempt to use that data, and so for most platforms there needs
> to be a "console=" line in the command line if a serial port is intended
> to be used as the console.
>
> With this series, if there is a /chosen/stdout-path property, and if
> that property points to a serial port node, then when the serial driver
> registers the port, the core uart_add_one_port() function will notice
> and if no console= argument was provided then add it as a preferred
> console.
>
> I've not tested this very extensively yet, but I want to get some
> feedback before I go further.
>
> The one downside with this approach is that it doesn't do anything for
> early console setup. That still needs to be added on a per-driver basis,
> but at least it shouldn't conflict with this approach.

Hey, what happened with this series?

Rob


\
 
 \ /
  Last update: 2014-06-12 04:21    [W:0.148 / U:1.756 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site