lkml.org 
[lkml]   [2014]   [May]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH 19/22] ARM: sunxi: Add earlyprintk support using R_UART (sun6i/sun8i)
On Mon, May 26, 2014 at 2:46 AM, Maxime Ripard
<maxime.ripard@free-electrons.com> wrote:
> Hi,
>
> On Fri, May 23, 2014 at 03:51:22PM +0800, Chen-Yu Tsai wrote:
>> sun6i/sun8i have a UART in the RTC block group, which can be used
>> as an early console. This is most useful on sun8i as UART0 is muxed
>> with MMC0, which is not available if we boot from MMC.
>>
>> Signed-off-by: Chen-Yu Tsai <wens@csie.org>
>> ---
>> arch/arm/Kconfig.debug | 10 ++++++++++
>> 1 file changed, 10 insertions(+)
>>
>> diff --git a/arch/arm/Kconfig.debug b/arch/arm/Kconfig.debug
>> index eab8ecb..9e22708 100644
>> --- a/arch/arm/Kconfig.debug
>> +++ b/arch/arm/Kconfig.debug
>> @@ -694,6 +694,14 @@ choice
>> Say Y here if you want kernel low-level debugging support
>> on Allwinner A1X based platforms on the UART1.
>>
>> + config DEBUG_SUNXI_R_UART
>> + bool "Kernel low-level debugging messages via sunXi R_UART"
>> + depends on ARCH_SUNXI
>
> It should rather depend on MACH_SUN8I.

I assume no sun6i devices would use it, or have pads available for it?
If so, then MACH_SUN8I makes sense.


ChenYu


\
 
 \ /
  Last update: 2014-05-26 12:21    [W:0.062 / U:0.084 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site