lkml.org 
[lkml]   [2014]   [May]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH v1 5/5] pci: keystone: add pcie driver based on designware core driver
Date
On Friday 16 May 2014 16:26:51 Murali Karicheri wrote:
> On 5/15/2014 2:20 PM, Arnd Bergmann wrote:
> > On Thursday 15 May 2014 13:45:08 Murali Karicheri wrote:
> >>>> +#ifdef CONFIG_PCI_KEYSTONE
> >>>> +/*
> >>>> + * The KeyStone PCIe controller has maximum read request size of 256 bytes.
> >>>> + */
> >>>> +static void quirk_limit_readrequest(struct pci_dev *dev)
> >>>> +{
> >>>> + int readrq = pcie_get_readrq(dev);
> >>>> +
> >>>> + if (readrq > 256)
> >>>> + pcie_set_readrq(dev, 256);
> >>>> +}
> >>>> +DECLARE_PCI_FIXUP_FINAL(PCI_ANY_ID, PCI_ANY_ID, quirk_limit_readrequest);
> >>>> +#endif /* CONFIG_PCI_KEYSTONE */
> >>> This doesn't work: you can't just limit do this for all devices just based
> >>> on PCI_KEYSTONE being enabled, you have to check if you are actually using
> >>> this controller.
> >>>
> >>> Arnd
> >> I assume, I need to check if PCI controller's vendor ID/ device ID
> >> match with the keystone
> >> PCI controller's ID and call pcie_set_readrq() for all of the slave
> >> PCI devices and do this fixup.
> >> Is this correct understanding? If you can point me to an example code
> >> for this that will be
> >> really helpful so that I can avoid re-inventing the wheel.
> > I think it would be best to move the quirk into the keystone pci driver
> > and compare compare the dev->driver pointer of the PCI controller device.
> >
> > Arnd
> Arnd,
>
> I will move this quirk to keystone pci driver. So in that case, I guess
> your original comment
> is not applicable as this quirk gets enabled only with PCI keystone
> driver enabled. Right?

Of course you still have to fix the bug, not just move the code into
the driver. Otherwise it's still broken for every machine after the keystone
driver is enabled.

I also agree with Jason that changing the PCI core to call
pcie_bus_configure_settings() would be a better way of dealing with this
if it solves the problem.

Arnd


\
 
 \ /
  Last update: 2014-05-19 14:41    [W:0.130 / U:0.644 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site