lkml.org 
[lkml]   [2014]   [Apr]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: Microblaze image hanging in qemu with 3.15-rc
On 04/25/2014 12:25 AM, Michal Simek wrote:
[ ... ]

>
> It should be pretty easy to fix it in timer_write function like this.
>
> diff --git a/hw/timer/xilinx_timer.c b/hw/timer/xilinx_timer.c
> index 6113b97..3ff1da9 100644
> --- a/hw/timer/xilinx_timer.c
> +++ b/hw/timer/xilinx_timer.c
> @@ -169,7 +169,7 @@ timer_write(void *opaque, hwaddr addr,
> if (value & TCSR_TINT)
> value &= ~TCSR_TINT;
>
> - xt->regs[addr] = value;
> + xt->regs[addr] = value & 0x7ff;
> if (value & TCSR_ENT)
> timer_enable(xt);
> break;
>

Hi Michal,

that fixes endianness detection, but the image is still hanging.

Here is the log:

NR_IRQS:33
/plb@0/interrupt-controller@81800000: num_irq=4, edge=0xa
ERROR: CPU CCF input clock not found
Reading TCSR0 returned 0x0, expected 0x1
Switch to big endian mode
/plb@0/timer@83c00000: irq=1
ERROR: timer CCF input clock not found
ERROR: Using CPU clock frequency
xilinx_timer_set_mode: shutdown
xilinx_timer_set_mode: periodic
sched_clock: 32 bits at 62MHz, resolution 16ns, wraps every 68719476720ns
Calibrating delay loop... QEMU: Terminated

I added a couple of log messages to make sure that the mode is detected correctly.
Any idea what else might be wrong ?

Thanks,
Guenter



\
 
 \ /
  Last update: 2014-04-26 15:41    [W:0.056 / U:0.032 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site