lkml.org 
[lkml]   [2014]   [Dec]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH RFC v2 00/14] Add support for i.MX MIPI DSI DRM driver
Hi Andy,

On 12/19/2014 02:33 PM, Andy Yan wrote:
> Hi Liu Ying:
>
> I foud Rockchip RK618 (a mfd function device with mipi dsi,lvds
> transmitter、HDMI TX、and audio codec,and
> controlled by the SOC from i2c ) have the same register layout with your
> i.MX MIPI DSI,which means RK618 MIPI
> DSI also have the Synopsys compatible DSI IP。So Would you please make
> this drives more platform independent?
>

I may try to place the Synopsys DesignWare MIPI DSI driver in the
drm/bridge directory and make it as less platform-dependant as
possible.

I have no access to the Rockchip RK618 chip and it's reference menu.
You probably may add the Rockchip part support later.

Regards,
Liu Ying

>
>
>
> At 2014-12-18 15:11:22, "Liu Ying" <Ying.Liu@freescale.com> wrote:
>>Hi,
>>
>>This series addressed almost all comments from Thierry Redding and Russell
>>on v1.
>>
>>This series adds support for i.MX MIPI DSI DRM driver.
>>Currently, the MIPI DSI driver only supports the burst with sync pulse mode.
>>
>>This series also includes a DRM panel driver for the Truly TFT480800-16-E panel
>>which is driven by the Himax HX8369A driver IC. The driver IC data sheet could
>>be found at [1]. As mentioned by the data sheet, the driver IC supports several
>>interface modes. Currently, the DRM panel driver only supports the MIPI DSI video
>>mode. New interface modes could be added later(perhaps, just like the way the DRM
>>simple panel driver supports both MIPI DSI interface panels and simple(parallel)
>>interface panels).
>>
>>The MIPI DSI feature is tested on i.MX6Q SabreSD board and i.MX6DL SabreSD board.
>>The MIPI DSI display could be enabled directly on i.MX6Q SabreSD board after
>>applying this series, because the 26.4MHz pixel clock the panel requires could be
>>derived from the IPU HSP clock(264MHz) with an integer divider.
>>On i.MX6DL SabreSD board, we need to manually disable the LVDS and HDMI displays in
>>the device tree blob, since the i.MX6DL IPU HSP clock is 198MHz at present, which
>>makes the pixel clock share the PLL5 video clock source with the LVDS and HDMI,
>>thus, the panel cannot get the pixel clock rate it wants.
>>
>>Patch 01/15 is needed to get a precise pixel clock rate(26.4MHz) from the PLL5 video
>>clock. If we don't have this patch, the pixel clock rate is about 20MHz, which
>>causes a horitonal shift on the display image.
>>
>>This series can be applied on the drm-next branch.
>>
>>[1] http://www.allshore.com/pdf/Himax_HX8369-A.pdf
>>
>>Liu Ying (14):
>> clk: divider: Correct parent clk round rate if no bestdiv is normally
>> found
>> of: Add vendor prefix for Himax Technologies Inc.
>> of: Add vendor prefix for Truly Semiconductors Limited
>> ARM: imx6q: Add GPR3 MIPI muxing control register field shift bits
>> definition
>> ARM: imx6q: clk: Add the video_27m clock
>> ARM: dts: imx6qdl: Move existing MIPI DSI ports into a new 'ports'
>> node
>> drm/dsi: Add a helper to get bits per pixel of MIPI DSI pixel format
>> drm: imx: Add MIPI DSI host controller driver
>> drm: panel: Add support for Himax HX8369A MIPI DSI panel
>> ARM: dtsi: imx6qdl: Add support for MIPI DSI host controller
>> ARM: dts: imx6qdl-sabresd: Add support for TRULY TFT480800-16-E MIPI
>> DSI panel
>> ARM: imx_v6_v7_defconfig: Cleanup for imx drm being moved out of
>> staging
>> ARM: imx_v6_v7_defconfig: Add support for MIPI DSI host controller
>> ARM: imx_v6_v7_defconfig: Add support for Himax HX8369A panel
>>
>> .../devicetree/bindings/drm/imx/mipi_dsi.txt | 78 ++
>> .../devicetree/bindings/panel/himax,hx8369a.txt | 41 +
>> .../devicetree/bindings/vendor-prefixes.txt | 2 +
>> arch/arm/boot/dts/imx6q.dtsi | 20 +-
>> arch/arm/boot/dts/imx6qdl-sabresd.dtsi | 20 +
>> arch/arm/boot/dts/imx6qdl.dtsi | 30 +-
>> arch/arm/configs/imx_v6_v7_defconfig | 17 +-
>> arch/arm/mach-imx/clk-imx6q.c | 1 +
>> drivers/clk/clk-divider.c | 3 +-
>> drivers/gpu/drm/imx/Kconfig | 6 +
>> drivers/gpu/drm/imx/Makefile | 1 +
>> drivers/gpu/drm/imx/imx-mipi-dsi.c | 1056 ++++++++++++++++++++
>> drivers/gpu/drm/panel/Kconfig | 5 +
>> drivers/gpu/drm/panel/Makefile | 1 +
>> drivers/gpu/drm/panel/panel-himax-hx8369a.c | 573 +++++++++++
>> include/drm/drm_mipi_dsi.h | 14 +
>> include/dt-bindings/clock/imx6qdl-clock.h | 3 +-
>> include/linux/mfd/syscon/imx6q-iomuxc-gpr.h | 1 +
>> 18 files changed, 1844 insertions(+), 28 deletions(-)
>> create mode 100644 Documentation/devicetree/bindings/drm/imx/mipi_dsi.txt
>> create mode 100644 Documentation/devicetree/bindings/panel/himax,hx8369a.txt
>> create mode 100644 drivers/gpu/drm/imx/imx-mipi-dsi.c
>> create mode 100644 drivers/gpu/drm/panel/panel-himax-hx8369a.c
>>
>>--
>>2.1.0
>>
>>_______________________________________________
>>dri-devel mailing list
>>dri-devel@lists.freedesktop.org
>>http://lists.freedesktop.org/mailman/listinfo/dri-devel
>
>
>


\
 
 \ /
  Last update: 2014-12-19 09:21    [W:0.728 / U:0.216 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site