lkml.org 
[lkml]   [2014]   [Oct]   [31]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v3 5/6] Documentation: dt-bindings: Add binding info for X-Gene QMTM UIO driver
On 31 October 2014 15:39, Mark Rutland <mark.rutland@arm.com> wrote:
>> >> +Required properties:
>> >> +- compatible: Should be "apm,xgene-qmtm"
>> >> +- reg: Address and length of the register set for the device. It contains the
>> >> + information of registers in the same order as described by reg-names.
>> >> +- reg-names: Should contain the register set names
>> >> + - "csr": QMTM control and status register address space.
>> >> + - "fabric": QMTM memory mapped access to queue states.
>> >> +- qpool: Points to the phandle of the node defining memory location for
>> >> + creating QMTM queues. This could point either to the reserved-memory
>> >> + node (as-per reserved memory bindings) or to the node of on-chip
>> >> + SRAM etc. It is expected that size and location of qpool memory will
>> >> + be configurable via bootloader.
>> >
>> > Is that on-chip SRAM part of the QMTM, or is that a shared part of the
>> > SoC?
>> Its not part of QMTM.
>>
>> >
>> > It feels odd to have a phandle that can go to completely different
>> > classes of node, especially as you will need to use a different API to
>> > acquire the memory region within Linux.
>> It is expected that phandle will point to a node whose first reg
>> property will be only for qpool memory.
>
> Even if that's true you will need to use completely different APIs for
> accessing that memory (so that the kernel can account the use of
> reserved-memory correctly), so this might not be the best design. It
> might be better to have qpool-sram and qpool-memory properties that
> point at an sram node or a reserved-memory node respectively.
Thanks, I will go as per your suggestion. I will add two properties
qpool-sram and qpool-memory to tackle this.
>
>> >
>> >> +- clocks: Reference to the clock entry.
>> >
>> > Just the one clock? Does the clock input to the QMTM have a name?
>> Just one input clock. There is no specific name of it.
>
> Ok.
>
>>
>> >
>> >> +- num-queues: Number of queues under this QMTM device.
>> >> +- devid: QMTM identification number for the system having multiple QMTM devices.
>> >> + This is used to form a unique id (a tuple of queue number and
>> >> + device id) for the queues belonging to this device.
>> >
>> > Is this just an arbitrary unique ID, or is this a non-probeable property
>> > of the HW? If the former, isn't the base address sufficient as a unique
>> > identifier?
>> Its a non-probeable property of the HW.
>
> Ok. That sounds fine then.
>

Thanks,
Ankit
> Thanks,
> Mark.


\
 
 \ /
  Last update: 2014-10-31 11:41    [W:0.045 / U:0.056 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site