lkml.org 
[lkml]   [2014]   [Oct]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [RFC PATCH 1/2] zap_pte_range: update addr when forcing flush after TLB batching faiure
From
On Wed, Oct 29, 2014 at 12:47 PM, Will Deacon <will.deacon@arm.com> wrote:
>
> I've cooked up something (see below), but it unfortunately makes a couple
> of minor changes to powerpc and microblaze to address redefinitions of
> some of the gather callbacks (tlb{start,end}vma, __tlb_remove_tlb_entry).
>
> On the plus side, it tidies up the force_flush case in zap_pte_range
> quite nicely (assuming I didn't screw it up again).

Yes, this looks fine to me. Looks like a good cleanup, and moves more
code to generic headers rather than having arch-specific stuff.

Ben, can you check that this is ok on powerpc? Who else should
double-check this due to having been involved in tlb flushing? But I
think this is good to go, modulo checking other architectures for
sanity.

Linus


\
 
 \ /
  Last update: 2014-10-29 22:41    [W:0.086 / U:0.396 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site