lkml.org 
[lkml]   [2014]   [Oct]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [RFC Patch] gpio: add GPIO hogging mechanism
Maxime Ripard <maxime.ripard@free-electrons.com> wrote on Wed [2014-Oct-29 11:45:59 +0100]:
> Hi,
>
> On Tue, Oct 21, 2014 at 03:09:58PM -0500, Benoit Parrot wrote:
> > Based on Boris Brezillion work this is a reworked patch
> > of his initial GPIO hogging mechanism.
> > This patch provides a way to initally configure specific GPIO
> > when the gpio controller is probe.
> >
> > The actual DT scanning to collect the GPIO specific data is performed
> > as part of the gpiochip_add().
> >
> > The purpose of this is to allows specific GPIOs to be configured
> > without any driver specific code.
> > This particularly usueful because board design are getting
> > increassingly complex and given SoC pins can now have upward
> > of 10 mux values a lot of connections are now dependent on
> > external IO muxes to switch various modes and combination.
> >
> > Specific drivers should not necessarily need to be aware of
> > what accounts to a specific board implementation. This board level
> > "description" should be best kept as part of the dts file.
> >
> > Signed-off-by: Benoit Parrot <bparrot@ti.com>
>
> I've been thinking about this for quite some time, it's good to see
> some progress on that :)
>
> However, I have a slightly different use case for it: the Allwinner
> SoCs have a vdd pin coming in for every gpio bank. Nothing out of the
> ordinary so far, except that some of the boards are using a
> GPIO-controlled regulator to feed another bank vdd. That obviously
> causes a chicken-egg issue, since for the gpio-regulator driver to
> probe, it needs to gpio driver, and for the gpio driver to probe, it
> needs the regulator driver.

Unless the gpio controlling the vdd pin is from the same bank your trying to power up
I do not see the issue here.

In this patch the gpio-hogs are setup as part of the gpio-controller probe function.

>
> I was thinking of solving this by enforcing gpio hogs, in order to
> have the gpio driver loading, grabing its gpios setting them to the
> right value to enable the current to flow in, and then let the
> regulator driver probe later on.
>
> I don't think it's possible with your current code, would it be
> something worth considering, or would someone have a better solution?

Unless I am missing something, this should work.

>
> Maxime
> --
> Maxime Ripard, Free Electrons
> Embedded Linux, Kernel and Android engineering
> http://free-electrons.com

Regards,
Benoit




\
 
 \ /
  Last update: 2014-10-29 18:01    [W:0.658 / U:0.012 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site