Messages in this thread | | | Date | Wed, 03 Jul 2013 13:31:47 +0200 | From | Sebastian Hesselbarth <> | Subject | Re: [PATCH v6 5/7] ARM: kirkwood: remove redundant DT board files |
| |
On 07/03/13 01:09, Arnaud Ebalard wrote: > Hi Sebastian, > > Sebastian Hesselbarth <sebastian.hesselbarth@gmail.com> writes: > >> With DT support for mv643xx_eth board specific init for some boards now >> is unneccessary. Remove those board files, Kconfig entries, and >> corresponding entries in kirkwood_defconfig. > > Applying above your set an old quilt cleaning patch Jason asked at some > point, it became empty except for arch/arm/mach_kirkwood/common.h in > which some declarations were left behind. If this is correct, can you > just merge the hunks below in your 5/7 in next round? > > AFAICT, only dnskw_init() remains, which matches the list of board-*.c > files in arch/arm/mach_kirkwood/ (i.e. board-dt.c and board-dnskw.c).
While updating the patch with yours, I stumbled upon MACH_TS219_DT that also remains because it includes tsx1x-common.c.
I cannot recall if Jason or Andrew said something about removing it..
Sebastian
| |