lkml.org 
[lkml]   [2013]   [Jul]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: 3.10.1: echo repair > sync_action causes hang on RAID-1 (2 x SSD)
On Sun, 21 Jul 2013 06:26:55 -0400 "Justin Piszcz" <jpiszcz@lucidpixels.com>
wrote:

> Hi,
>
> When I run repair on an MD-RAID1 sync_action, the speed slows down and it
> stays like this (below) for hours.
>
> The system is then completely unresponsive to user input. I have replaced a
> failing SSD; however, after a check, mismatch_cnt seems to increase over
> time. When I run repair, the system freezes to user-input. Has anyone else
> run into this issue with a RAID-1 volume (2 x SSD) using 0.90 metadata?
> Long ago I used to use this same configuration with two physical disks and
> there was never a problem.
>
> Even though I left a root shell open, this has no effect to break the
> resync:
> # echo idle > /sys/devices/virtual/block/md1/md/sync_action
>
> Every 1.0s: cat /proc/mdstat Sun Jul 21 06:15:38
> 2013
>
> Personalities : [raid1]
> md1 : active raid1 sdc2[0] sdb2[1]
> 233381376 blocks [2/2] [UU]
> [>....................] resync = 0.0% (151616/233381376)
> finish=36171.5min speed=107K/sec
>
> md0 : active raid1 sdc1[0] sdb1[1]
> 1048512 blocks [2/2] [UU]
>
> unused devices: <none>
>
> 10 minutes later:
>
> 233381376 blocks [2/2] [UU]
> [>....................] resync = 0.0% (151616/233381376)
> finish=52219.3min speed=74K/sec
>
> Where it hangs (151616) or elsewhere, has been different each time I watched
> it, it does not appear to be hanging at the same block each time.
>

Hi Justin,
this is a known bug. Fix has been accepted into mainline for 3.11-rc2.
Hopefully it will get into 3.10.3 (too late for 3.10.2).

NeilBrown
[unhandled content-type:application/pgp-signature]
\
 
 \ /
  Last update: 2013-07-22 01:21    [W:0.068 / U:0.348 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site