lkml.org 
[lkml]   [2013]   [Jun]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH 04/11] tracing: fix disabling of soft disable
From
Date
On Fri, 2013-06-21 at 20:12 +0900, Masami Hiramatsu wrote:
> (2013/06/21 3:31), Tom Zanussi wrote:
> > The comment on the soft disable 'disable' case of
> > __ftrace_event_enable_disable() states that the soft disable bit
> > should be cleared in that case, but currently only the soft mode bit
> > is actually cleared.
> >
> > This essentially leaves the standard non-soft-enable enable/disable
> > paths as the only way to clear the soft disable flag, but the soft
> > disable bit should also be cleared when removing a trigger with '!'.
>
> Indeed, the soft-disabled flag may remain after the event itself
> disabled. However that soft-disabled flag will be cleared when
> the event is re-enabled. it seems no bad side-effect.
>
> Thus I doubt this patch is separately required. I guess this is
> required for adding new trigger flag, isn't it? :)

Tom, I'm guessing Masami is correct here. It's needed for the trigger
work to work, correct?

Either way, I probably could add it as a clean up patch regardless. I'll
just have to test the hell out of it some more, as the accounting for
soft-disable vs real disable was a PITA.

-- Steve



\
 
 \ /
  Last update: 2013-06-21 23:01    [W:0.055 / U:1.420 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site