lkml.org 
[lkml]   [2012]   [Aug]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Date
SubjectRe: [PATCH] Fixes for dw_dmac and atmel-mci for AP700x
From
Hi Hein,

I have added linux-kernel list in cc as there might be other users of
this patch.
Also, please try to keep spear-devel list in cc for dw_dmac as we are using this
driver for SPEAr.

On Sun, Aug 19, 2012 at 9:36 PM, Hein Tibosch <hein_tibosch@yahoo.es> wrote:
> Hi Hans-Christian,
>
> Do you know to which list I could send the patch(es) below?
>
> Viresh Kumar: did you have an urgent reason to replace __raw_readl
> and __raw_writel with readl/writel in the dw_dmac module?
> (see http://lists.infradead.org/pipermail/linux-arm-kernel/2011-March/044799.html)
>
> Here's a draft:
>
> Because of the changes since 2.6.38 to dw_dmac.c and atmel-mci.c,
> the MCI driver on the AP700x platforms didn't work anymore using DMA.
> The PIO method still worked well.
>
> I found several problems. The patch below makes it work again.
> It was tested on an atngw100 board.
>
> atmel-mci:
> - The AP700x has an MCI controller with version 0x210
> Therefor it was supposed to work the PDC (peripheral DMA
> controller). However, in this CPU the PDC is not connected
> to the MCI.
> - When using DMA, the driver was accessing a register ATMCI_DMA
> at offset 0x50, which is undefined for the AP700x. But it
> probably doesn't hurt either...
>
> dw_dmac:
> - After 2.6.39, the registers were accessed using readl/writel
> in stead of the __raw_readl and __raw_writel causing a 16-bit
> swap of all values (little endian access)

Ahhhh!! Firstly we can't use __raw* for architectures >= ARMv6. It is not
only for endianess but for memory barriers. Why are they getting swapped
for your case? Does your processor and dw_dmac have different endianess?

And if i am not wrong, we should always try not to use __raw* variants just
due to endianess things... instead use either readl/writel OR
readl_/writel_ relaxed.
I am not sure if relaxed versions are available for architectures
other than ARM.

> - Access to memory was sometimes done in chunks of 64-bits,
> which gives an undefined value of 0x03 for SRC/DST_TR_WIDTH
> field in the CTLxL register

Looks fine. But there should be a separate patch for this.

> - The SMS field in the CTLxL register received the wrong value:
> 0 in stead of 1

I believe it is not for dw_dmac?

--
viresh

> Signed-off-by: Hein Tibosch <hein_tibosch@yahoo.es>
> ---
> arch/avr32/mach-at32ap/at32ap700x.c | 6 ++++++
> drivers/dma/dw_dmac.c | 8 ++++++++
> drivers/dma/dw_dmac_regs.h | 8 ++++----
> drivers/mmc/host/atmel-mci.c | 19 ++++++++++++++++---
> 4 files changed, 34 insertions(+), 7 deletions(-)
>
> diff --git a/arch/avr32/mach-at32ap/at32ap700x.c b/arch/avr32/mach-at32ap/at32ap700x.c
> index 0445c4f..06b6eff 100644
> --- a/arch/avr32/mach-at32ap/at32ap700x.c
> +++ b/arch/avr32/mach-at32ap/at32ap700x.c
> @@ -1355,6 +1355,12 @@ at32_add_device_mci(unsigned int id, struct mci_platform_data *data)
> | DWC_CFGH_DST_PER(1));
> slave->sdata.cfg_lo &= ~(DWC_CFGL_HS_DST_POL
> | DWC_CFGL_HS_SRC_POL);
> + /* value for SMS: Source Master Select */
> + slave->sdata.src_master = 1;
> + /* value for DMS: Destination Master Select */
> + slave->sdata.dst_master = 0;
> + /* SRC/DST_TR_WIDTH register only accepts 0,1,2 */
> + slave->sdata.max_mem_width = 2;
> data->dma_slave = slave;
> diff --git a/drivers/dma/dw_dmac.c b/drivers/dma/dw_dmac.c
> index 7212961..a4bdf1d 100644
> --- a/drivers/dma/dw_dmac.c
> +++ b/drivers/dma/dw_dmac.c
> @@ -754,6 +754,10 @@ dwc_prep_slave_sg(struct dma_chan *chan, struct scatterlist *sgl,
> mem_width = 1;
> else
> mem_width = 0;
> + /* Some controllers don't support 64-bits mem access */
> + if (dws->max_mem_width &&
> + mem_width > dws->max_mem_width)
> + mem_width = dws->max_mem_width;
> slave_sg_todev_fill_desc:
> desc = dwc_desc_get(dwc);
> @@ -821,6 +825,10 @@ slave_sg_todev_fill_desc:
> mem_width = 1;
> else
> mem_width = 0;
> + /* Some controllers don't support 64-bits mem access */
> + if (dws->max_mem_width &&
> + mem_width > dws->max_mem_width)
> + mem_width = dws->max_mem_width;
> slave_sg_fromdev_fill_desc:
> desc = dwc_desc_get(dwc);
> diff --git a/drivers/dma/dw_dmac_regs.h b/drivers/dma/dw_dmac_regs.h
> index f298f69..b380d5f 100644
> --- a/drivers/dma/dw_dmac_regs.h
> +++ b/drivers/dma/dw_dmac_regs.h
> @@ -176,9 +176,9 @@ __dwc_regs(struct dw_dma_chan *dwc)
> }
> #define channel_readl(dwc, name) \
> - readl(&(__dwc_regs(dwc)->name))
> + __raw_readl(&(__dwc_regs(dwc)->name))
> #define channel_writel(dwc, name, val) \
> - writel((val), &(__dwc_regs(dwc)->name))
> + __raw_writel((val), &(__dwc_regs(dwc)->name))
> static inline struct dw_dma_chan *to_dw_dma_chan(struct dma_chan *chan)
> {
> @@ -202,9 +202,9 @@ static inline struct dw_dma_regs __iomem *__dw_regs(struct dw_dma *dw)
> }
> #define dma_readl(dw, name) \
> - readl(&(__dw_regs(dw)->name))
> + __raw_readl(&(__dw_regs(dw)->name))
> #define dma_writel(dw, name, val) \
> - writel((val), &(__dw_regs(dw)->name))
> + __raw_writel((val), &(__dw_regs(dw)->name))
> #define channel_set_bit(dw, reg, mask) \
> dma_writel(dw, reg, ((mask) << 8) | (mask))
> diff --git a/drivers/mmc/host/atmel-mci.c b/drivers/mmc/host/atmel-mci.c
> index f2c115e..b78a674 100644
> --- a/drivers/mmc/host/atmel-mci.c
> +++ b/drivers/mmc/host/atmel-mci.c
> @@ -75,6 +75,7 @@ struct atmel_mci_caps {
> bool has_pdc;
> bool has_cfg_reg;
> bool has_cstor_reg;
> + bool has_dma_reg;
> bool has_highspeed;
> bool has_rwproof;
> bool has_odd_clk_div;
> @@ -411,7 +412,7 @@ static int atmci_regs_show(struct seq_file *s, void *v)
> atmci_show_status_reg(s, "SR", buf[ATMCI_SR / 4]);
> atmci_show_status_reg(s, "IMR", buf[ATMCI_IMR / 4]);
> - if (host->caps.has_dma) {
> + if (host->caps.has_dma_reg) {
> u32 val;
> val = buf[ATMCI_DMA / 4];
> @@ -767,7 +768,7 @@ static void atmci_dma_complete(void *arg)
> dev_vdbg(&host->pdev->dev, "DMA complete\n");
> - if (host->caps.has_dma)
> + if (host->caps.has_dma_reg)
> /* Disable DMA hardware handshaking on MCI */
> atmci_writel(host, ATMCI_DMA, atmci_readl(host, ATMCI_DMA) & ~ATMCI_DMAEN);
> @@ -954,7 +955,9 @@ atmci_prepare_data_dma(struct atmel_mci *host, struct mmc_data *data)
> maxburst = atmci_convert_chksize(host->dma_conf.dst_maxburst);
> }
> - atmci_writel(host, ATMCI_DMA, ATMCI_DMA_CHKSIZE(maxburst) | ATMCI_DMAEN);
> + if (host->caps.has_dma_reg)
> + atmci_writel(host, ATMCI_DMA,
> + ATMCI_DMA_CHKSIZE(maxburst) | ATMCI_DMAEN);
> sglen = dma_map_sg(chan->device->dev, data->sg,
> data->sg_len, direction);
> @@ -2203,7 +2206,11 @@ static void __init atmci_get_cap(struct atmel_mci *host)
> "version: 0x%x\n", version);
> host->caps.has_dma = 0;
> +#if defined(CONFIG_CPU_AT32AP700X)
> + host->caps.has_pdc = 0;
> +#else
> host->caps.has_pdc = 1;
> +#endif
> host->caps.has_cfg_reg = 0;
> host->caps.has_cstor_reg = 0;
> host->caps.has_highspeed = 0;
> @@ -2221,6 +2228,7 @@ static void __init atmci_get_cap(struct atmel_mci *host)
> case 0x300:
> #ifdef CONFIG_AT_HDMAC
> host->caps.has_dma = 1;
> + host->caps.has_dma_reg = 1;
> #else
> dev_info(&host->pdev->dev,
> "has dma capability but dma engine is not selected, then use pio\n");
> @@ -2230,6 +2238,11 @@ static void __init atmci_get_cap(struct atmel_mci *host)
> host->caps.has_cstor_reg = 1;
> host->caps.has_highspeed = 1;
> case 0x200:
> +#if defined(CONFIG_DW_DMAC) && defined(CONFIG_MMC_ATMELMCI_DMA)
> + host->caps.has_dma = 1;
> + dev_info(&host->pdev->dev,
> + "using dma (AP7000)\n");
> +#endif
> host->caps.has_rwproof = 1;
> host->caps.need_blksz_mul_4 = 0;
> case 0x100:
> --
> 1.7.8.0
>
>


\
 
 \ /
  Last update: 2012-08-21 07:21    [W:0.254 / U:0.024 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site