lkml.org 
[lkml]   [2012]   [Jul]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 00/36] AArch64 Linux kernel port
Hi!

> > > The AArch32 execution mode is optional, so it depends on the actual CPU
> > > implementation (while AArch64 is mandatory). If the implementation
> > > supports it, the most likely scenario for AArch32 at kernel level is in
> > > virtual machines or the secure OS. I'll explain below why.
> > >
> > > The exception (or privilege) levels on an ARMv8 architecture look like
> > > this:
> > >
> > > Secure World Normal World
> > > +-----+
> > > | EL3 | - Secure monitor
> > > +-----+
> > > +-----+
> > > | EL2 | - Hypervisor (normal world only)
> > > +-----+
> > > +-----+ +-----+
> > > | EL1 | | EL1 | - OS kernel (secure or normal)
> > > +-----+ +-----+
> > > +-----+ +-----+
> > > | EL0 | | EL0 | - User apps (secure or normal)
> > > +-----+ +-----+
> > >
> > > In theory, each of these levels (implementation specific) can run both
> > > AArch32 and AArch64 modes. There is however a restriction on how the
> > > mode switching is done - this can only happen on a change of exception
> > > level. When going up the EL the register width (RW) can never go down. A
> > > lower EL can never have a higher RW than a higher EL.
> > >
> > > Additionally, the RW (the AArch32/AArch64 mode) for an EL is controlled
> > > by the next higher level (with EL3 hard-wired). An EL cannot cause
> > > itself to switch between AArch32 and AArch64.
> >
> > So is the highest level always hardwired to 64-bit on ARMv8?
>
> If an implementation supports AArch32 at EL3 there could be some
> physical (or some FPGA config) switch to choose between the two. But
> since AArch64 is mandated, I don't see why one would force AArch32 at
> EL3 and therefore all lower exception levels (and make a big part of the
> processor unused).

Actually I see one ... and I can bet it will happen.

So you create that shiny new ARMv8 compliant CPU, 8 cores, 2GHz. HTC
will want to use it with 1GB of RAM... and put around exiting OMAP
perihepals.

At that point they will have choice of either:

1) going arm64, with no advantages and disadvantage of having to
debug/stabilize arm64 kernel+toolchain (+hardware; yes, early 64bit
hardware usually has security bugs), and to port the omap code from
arch/arm to arch/arm64

2) just putting that 8 cores into arm32 mode. Yes, a bit of silicion
is unused. But if the ARMv8 has most cores/biggest performance, it
still makes sense, and 32bits is inherently faster due to pointers
being smaller.

I know I did boot early amd64 machines in 32bit mode; avoiding all the
64bit complexity. I'm pretty sure someone will want to do that on arm.

Now, you may say "we'll just refuse to merge 32-bit support for 64-bit
capable machines"... I believe that's unneccessarily cruel... and may
rule out multi-user servers due to security problems.

Pavel
--
(english) http://www.livejournal.com/~pavelmachek
(cesky, pictures) http://atrey.karlin.mff.cuni.cz/~pavel/picture/horses/blog.html


\
 
 \ /
  Last update: 2012-07-16 15:01    [W:0.229 / U:0.296 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site