lkml.org 
[lkml]   [2012]   [Jun]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [RFC PATCH 0/5] omap: add ocp2scp as a misc driver
Date
"ABRAHAM, KISHON VIJAY" <kishon@ti.com> writes:

> Hi Kevin, Benoit, Paul,
>
> On Fri, Jun 1, 2012 at 2:16 AM, Arnd Bergmann <arnd@arndb.de> wrote:
>> On Thursday 31 May 2012, ABRAHAM, KISHON VIJAY wrote:
>>> > I would mark the multiplexed device compatible with "simple-bus", which
>>> > results in the child devices automatically getting added.
>>>
>>> hmm.. ocp2scp has a sysconfig register and it also has a module mode
>>> by which it can be enabled/disabled. I was making use of pm_runtime
>>> API's to control these registers (Apart from creating child devices,
>>> the driver also has a call to pm_runtime_enable).
>>
>> I see.
>>
>>> I'm not sure if with
>>> "simple-bus" we'll be able to do those. I have to check on that.
>>
>> How about making it compatible with both "simple-bus" and something
>> that handles the pm_runtime requirements?
>>
>> I don't understand enough of what needs to be done for pm_runtime
>> across a lot of devices, but I'd hope that it should be possible
>> to do that in a generic way based on the device definition.
>
> Is there already exists a generic way for handling pm_runtime
> requirements (as simple as doing a pm_runtime_enable on a device).

As you've discovered, the runtime PM core handles the parent/child
relationships already.

> So the actual problem is we have ocp2scp as parent and usb2phy and
> usb3phy as the child device. ocp2scp has the sysconfig register and it
> can be controlled using module mode bit (both of this can be
> controlled by pm_runtime). Whenever usb controller(dwc3/musb) wants to
> enable a phy, it calls an exported API in usb2/usb3 phy to enable it.
> These API's have pm_runtime_get_sync on usb2/usb3 device which in-turn
> calls pm_runtime_get_sync of ocp2scp because of parent->child
> relationship (For this both usb2/usb3 phy and ocp2scp devices should
> have called pm_runtime_enable). All I'm trying is to find a place to
> have pm_runtime_enable for ocp2scp.

Maybe I'm not following, but why can't it be in the driver?

Kevin



\
 
 \ /
  Last update: 2012-06-12 19:41    [W:0.076 / U:1.260 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site