[lkml]   [2012]   [May]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
    SubjectRe: [PATCH 2/3] MFD: twl6040: Allocate IRQ numbers dynamically
    On 05/04/2012 03:17 PM, Mark Brown wrote:
    >> You mean on devices like twl6040, twl6030, twl4030 (I2C MFD devices)?
    >> Or "irq expander" type of devices?
    > The latter, and also just any driver that delivers an interrupt via a
    > GPIO on OMAP - if the GPIO IRQ numbers are all dynamically allocated
    > then it gets hard to register an off-chip device and tell it which
    > interrupt to request.

    For GPIO IRQ there's the gpio_to_irq() call which returns the mapped IRQ
    number for the given GPIO.
    If there is "irq expander" type of chip I assume it would have similar
    way to get the IRQ number based on either GPIO number or some other
    enumeration value.
    The twl6040 does not have such a feature. The interrupts are generated
    internally and it has one IRQ line towards the host. We have nested
    interrupts for the childs (plug detect is handled by ASoC codec, Vibra
    overcurrent is handled by the vibra driver, etc).
    Client drivers got their interrupts via platform_get_irq(); they does
    not need to know anything about irq_base, or where the IRQ number has
    been mapped.

    To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
    the body of a message to
    More majordomo info at
    Please read the FAQ at

     \ /
      Last update: 2012-05-04 14:41    [W:0.026 / U:2.148 seconds]
    ©2003-2017 Jasper Spaans. hosted at Digital OceanAdvertise on this site