[lkml]   [2012]   [Apr]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
    Patch in this message
    Subject[PATCH v4 5/10] ARM: LPC32xx: Remove obsolete platform Kconfig
    This patch removes two Kconfig options now unused (the network driver is
    configured via DT now).

    Signed-off-by: Roland Stigge <>


    Applies to v3.4-rc3

    --- linux-2.6.orig/arch/arm/mach-lpc32xx/Kconfig
    +++ linux-2.6/arch/arm/mach-lpc32xx/Kconfig
    @@ -29,30 +29,4 @@ config ARCH_LPC32XX_UART6_SELECT


    -menu "LPC32XX chip components"
    - bool "Use IRAM for network buffers"
    - default y
    - help
    - Say Y here to use the LPC internal fast IRAM (i.e. 256KB SRAM) as
    - network buffer. If the total combined required buffer sizes is
    - larger than the size of IRAM, then SDRAM will be used instead.
    - This can be enabled safely if the IRAM is not intended for other
    - uses.
    - bool "Check to enable MII support or leave disabled for RMII support"
    - help
    - Say Y here to enable MII support, or N for RMII support. Regardless of
    - which support is selected, the ethernet interface driver needs to be
    - selected in the device driver networking section.
    - The PHY3250 reference board uses RMII, so users of this board should
    - say N.

     \ /
      Last update: 2012-04-19 15:03    [W:0.022 / U:0.024 seconds]
    ©2003-2016 Jasper Spaans. hosted at Digital OceanAdvertise on this site