lkml.org 
[lkml]   [2012]   [Apr]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 27/37] atl1c: refine SERDES-clock related code
Date
bit 17/18 of reg1424 must be clear for l2cb 1.x, or it will cause
the write-reg operation fail without cable connected.
so, please do connect the cable when apply this patch to the driver
to make sure these 2bits are cleared by new driver.
The revised code is move to al1c_reset_mac.
SERDES register definition is refined as well.

when do reset MAC, speed/duplex control right should be transferred
to software before do PHY auto-neg -- by bit MASTER_CTRL_SPEED_MODE_SW.
SERDES register definition is refined as well.

Signed-off-by: xiong <xiong@qca.qualcomm.com>
Tested-by: Liu David <dwliu@qca.qualcomm.com>
---
drivers/net/ethernet/atheros/atl1c/atl1c_ethtool.c | 2 +-
drivers/net/ethernet/atheros/atl1c/atl1c_hw.h | 34 +++++++++++------
drivers/net/ethernet/atheros/atl1c/atl1c_main.c | 40 +++++++++++++-------
3 files changed, 49 insertions(+), 27 deletions(-)
diff --git a/drivers/net/ethernet/atheros/atl1c/atl1c_ethtool.c b/drivers/net/ethernet/atheros/atl1c/atl1c_ethtool.c
index ce63615..ac44538 100644
--- a/drivers/net/ethernet/atheros/atl1c/atl1c_ethtool.c
+++ b/drivers/net/ethernet/atheros/atl1c/atl1c_ethtool.c
@@ -153,7 +153,7 @@ static void atl1c_get_regs(struct net_device *netdev,
AT_READ_REG(hw, REG_LINK_CTRL, p++);
AT_READ_REG(hw, REG_IDLE_STATUS, p++);
AT_READ_REG(hw, REG_MDIO_CTRL, p++);
- AT_READ_REG(hw, REG_SERDES_LOCK, p++);
+ AT_READ_REG(hw, REG_SERDES, p++);
AT_READ_REG(hw, REG_MAC_CTRL, p++);
AT_READ_REG(hw, REG_MAC_IPG_IFG, p++);
AT_READ_REG(hw, REG_MAC_STA_ADDR, p++);
diff --git a/drivers/net/ethernet/atheros/atl1c/atl1c_hw.h b/drivers/net/ethernet/atheros/atl1c/atl1c_hw.h
index 85623cc..672217d 100644
--- a/drivers/net/ethernet/atheros/atl1c/atl1c_hw.h
+++ b/drivers/net/ethernet/atheros/atl1c/atl1c_hw.h
@@ -366,18 +366,28 @@ int atl1c_write_phy_ext(struct atl1c_hw *hw, u8 dev_addr,
#define BIST1_FUSE_FLAG 0x4

/* SerDes Lock Detect Control and Status Register */
-#define REG_SERDES_LOCK 0x1424
-#define SERDES_LOCK_DETECT 0x1 /* SerDes lock detected. This signal
- * comes from Analog SerDes */
-#define SERDES_LOCK_DETECT_EN 0x2 /* 1: Enable SerDes Lock detect function */
-#define SERDES_LOCK_STS_SELFB_PLL_SHIFT 0xE
-#define SERDES_LOCK_STS_SELFB_PLL_MASK 0x3
-#define SERDES_OVCLK_18_25 0x0
-#define SERDES_OVCLK_12_18 0x1
-#define SERDES_OVCLK_0_4 0x2
-#define SERDES_OVCLK_4_12 0x3
-#define SERDES_MAC_CLK_SLOWDOWN 0x20000
-#define SERDES_PYH_CLK_SLOWDOWN 0x40000
+#define REG_SERDES 0x1424
+#define SERDES_PHY_CLK_SLOWDOWN BIT(18)
+#define SERDES_MAC_CLK_SLOWDOWN BIT(17)
+#define SERDES_SELFB_PLL_MASK 0x3UL
+#define SERDES_SELFB_PLL_SHIFT 14
+#define SERDES_PHYCLK_SEL_GTX BIT(13) /* 1:gtx_clk, 0:25M */
+#define SERDES_PCIECLK_SEL_SRDS BIT(12) /* 1:serdes,0:25M */
+#define SERDES_BUFS_RX_EN BIT(11)
+#define SERDES_PD_RX BIT(10)
+#define SERDES_PLL_EN BIT(9)
+#define SERDES_EN BIT(8)
+#define SERDES_SELFB_PLL_SEL_CSR BIT(6) /* 0:state-machine,1:csr */
+#define SERDES_SELFB_PLL_CSR_MASK 0x3UL
+#define SERDES_SELFB_PLL_CSR_SHIFT 4
+#define SERDES_SELFB_PLL_CSR_4 3 /* 4-12% OV-CLK */
+#define SERDES_SELFB_PLL_CSR_0 2 /* 0-4% OV-CLK */
+#define SERDES_SELFB_PLL_CSR_12 1 /* 12-18% OV-CLK */
+#define SERDES_SELFB_PLL_CSR_18 0 /* 18-25% OV-CLK */
+#define SERDES_VCO_SLOW BIT(3)
+#define SERDES_VCO_FAST BIT(2)
+#define SERDES_LOCK_DETECT_EN BIT(1)
+#define SERDES_LOCK_DETECT BIT(0)

/* MAC Control Register */
#define REG_MAC_CTRL 0x1480
diff --git a/drivers/net/ethernet/atheros/atl1c/atl1c_main.c b/drivers/net/ethernet/atheros/atl1c/atl1c_main.c
index ef431c9..a85f2af 100644
--- a/drivers/net/ethernet/atheros/atl1c/atl1c_main.c
+++ b/drivers/net/ethernet/atheros/atl1c/atl1c_main.c
@@ -1002,7 +1002,6 @@ static void atl1c_configure_des_ring(struct atl1c_adapter *adapter)
struct atl1c_rrd_ring *rrd_ring = &adapter->rrd_ring;
struct atl1c_tpd_ring *tpd_ring = (struct atl1c_tpd_ring *)
adapter->tpd_ring;
- u32 data;

/* TPD */
AT_WRITE_REG(hw, REG_TX_BASE_ADDR_HI,
@@ -1046,13 +1045,6 @@ static void atl1c_configure_des_ring(struct atl1c_adapter *adapter)
AT_WRITE_REG(hw, REG_TXF_WATER_MARK, 0); /* TX watermark, to enter l1 state.*/
AT_WRITE_REG(hw, REG_RXD_DMA_CTRL, 0); /* RXD threshold.*/
}
- if (hw->nic_type == athr_l2c_b || hw->nic_type == athr_l1d_2) {
- /* Power Saving for L2c_B */
- AT_READ_REG(hw, REG_SERDES_LOCK, &data);
- data |= SERDES_MAC_CLK_SLOWDOWN;
- data |= SERDES_PYH_CLK_SLOWDOWN;
- AT_WRITE_REG(hw, REG_SERDES_LOCK, data);
- }
/* Load all of base address above */
AT_WRITE_REG(hw, REG_LOAD_PTR, 1);
}
@@ -1175,7 +1167,7 @@ static int atl1c_reset_mac(struct atl1c_hw *hw)
{
struct atl1c_adapter *adapter = (struct atl1c_adapter *)hw->adapter;
struct pci_dev *pdev = adapter->pdev;
- u32 master_ctrl_data = 0;
+ u32 ctrl_data = 0;

AT_WRITE_REG(hw, REG_IMR, 0);
AT_WRITE_REG(hw, REG_ISR, ISR_DIS_INT);
@@ -1187,10 +1179,9 @@ static int atl1c_reset_mac(struct atl1c_hw *hw)
* the current PCI configuration. The global reset bit is self-
* clearing, and should clear within a microsecond.
*/
- AT_READ_REG(hw, REG_MASTER_CTRL, &master_ctrl_data);
- master_ctrl_data |= MASTER_CTRL_OOB_DIS;
- AT_WRITE_REG(hw, REG_MASTER_CTRL,
- master_ctrl_data | MASTER_CTRL_SOFT_RST);
+ AT_READ_REG(hw, REG_MASTER_CTRL, &ctrl_data);
+ ctrl_data |= MASTER_CTRL_OOB_DIS;
+ AT_WRITE_REG(hw, REG_MASTER_CTRL, ctrl_data | MASTER_CTRL_SOFT_RST);

AT_WRITE_FLUSH(hw);
msleep(10);
@@ -1202,7 +1193,28 @@ static int atl1c_reset_mac(struct atl1c_hw *hw)
" disabled for 10ms second\n");
return -1;
}
- AT_WRITE_REG(hw, REG_MASTER_CTRL, master_ctrl_data);
+ AT_WRITE_REG(hw, REG_MASTER_CTRL, ctrl_data);
+
+ /* driver control speed/duplex */
+ AT_READ_REG(hw, REG_MAC_CTRL, &ctrl_data);
+ AT_WRITE_REG(hw, REG_MAC_CTRL, ctrl_data | MAC_CTRL_SPEED_MODE_SW);
+
+ /* clk switch setting */
+ AT_READ_REG(hw, REG_SERDES, &ctrl_data);
+ switch (hw->nic_type) {
+ case athr_l2c_b:
+ ctrl_data &= ~(SERDES_PHY_CLK_SLOWDOWN |
+ SERDES_MAC_CLK_SLOWDOWN);
+ AT_WRITE_REG(hw, REG_SERDES, ctrl_data);
+ break;
+ case athr_l2c_b2:
+ case athr_l1d_2:
+ ctrl_data |= SERDES_PHY_CLK_SLOWDOWN | SERDES_MAC_CLK_SLOWDOWN;
+ AT_WRITE_REG(hw, REG_SERDES, ctrl_data);
+ break;
+ default:
+ break;
+ }

return 0;
}
--
1.7.7


\
 
 \ /
  Last update: 2012-04-13 02:23    [from the cache]
©2003-2014 Jasper Spaans. Advertise on this site