lkml.org 
[lkml]   [2012]   [Mar]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] ARM: OMAP: Add support for AM35xx UART4/ttyO3
On 18/10/2011 20:47, Kyle Manna wrote:
> Add hwmod support to enable access to UART4 of the AM35xx series of
> chips. The UART4 device referenced from the TRM will show up as ttyO3.
>
> This was tested on an AM3505.
>
> Signed-off-by: Kyle Manna <kyle.manna@fuel7.com>
> ---

Hi Kyle,

> arch/arm/mach-omap2/clock3xxx_data.c | 11 ++++++
> arch/arm/mach-omap2/omap_hwmod_3xxx_data.c | 52 ++++++++++++++++++++++++++++
> arch/arm/mach-omap2/prcm-common.h | 2 +
> arch/arm/plat-omap/include/plat/irqs.h | 2 +-
> arch/arm/plat-omap/include/plat/serial.h | 1 +
> 5 files changed, 67 insertions(+), 1 deletions(-)

Can I gently ask you which pinmux setup do you use to test your patch ?

I am trying to make uart4 working on a am3517 with mainline kernel
(3.3+, your patch is merged). However, on my board the uart4 pins are
shared with the camera, and not with SD, as maybe is more common. I set
the pinmux to switch the pins (gpio_95 / gpio_96 / gpio_97 /gpio_98) to
the uart4, and ttyO3 is registered and available, and thanks your patch
both clocks iclk and fclk are active. However, I cannot see activity on
the tx line if I try to send some characters.

Maybe do you use the same pinmux and am I forgetting something else ?

Thanks,
Stefano Babic

--
=====================================================================
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic@denx.de
=====================================================================


\
 
 \ /
  Last update: 2012-03-22 17:13    [W:0.070 / U:0.120 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site