Messages in this thread |  | | | Date | Thu, 9 Feb 2012 15:58:05 -0800 | | From | Shawn Guo <> | | Subject | Re: [PATCH v4 4/4] gpio: pl061: enable interrupts with DT style binding |
| |
On Thu, Feb 09, 2012 at 04:03:10PM -0600, Rob Herring wrote: > > On 02/09/2012 02:04 PM, Shawn Guo wrote: > > On Fri, Feb 03, 2012 at 04:35:12PM -0600, Rob Herring wrote: > > ... > >> @@ -126,18 +127,16 @@ static void pl061_set_value(struct gpio_chip *gc, unsigned offset, int value) > >> static int pl061_to_irq(struct gpio_chip *gc, unsigned offset) > >> { > >> struct pl061_gpio *chip = container_of(gc, struct pl061_gpio, gc); > >> - > >> - if (chip->irq_base <= 0) > >> - return -EINVAL; > >> - > >> - return chip->irq_base + offset; > >> + if (!chip->irq_gc) > >> + return -ENXIO; > >> + return irq_find_mapping(chip->irq_gc->domain, offset); > > > > If I understand the driver correctly, it will add a linear domain for > > dt case. Do you have code somewhere creating the mapping before this > > irq_find_mapping gets called here? The reason I'm asking this is I > > have to call irq_create_mapping rather than irq_find_mapping here to > > get imx gpio driver working with linear domain, otherwise the > > irq_find_mapping call will fail. > > > > Right, the user has to call irq_of_parse_and_map (which calls > irq_create_mapping ultimately). Interrupts are allocated on demand. The > dts needs to declare the gpio controller as an interrupt-controller and > the node using the gpio line needs to set its interrupt parent and > interrupt connection > Yes, that's how dt users use irq. But since I'm trying to make the imx gpio irq_domain as linear for both non-dt and dt users. Calling irq_create_mapping here may make sense for me, since it will not require all these non-dt users change the way they use gpio irq.
Even for dt users, there may have some case that can not work in the way we expect.
soc { #address-cells = <1>; #size-cells = <1>; compatible = "simple-bus"; interrupt-parent = <&tzic>; ranges; esdhc@70008000 { /* ESDHC2 */ compatible = "fsl,imx51-esdhc"; reg = <0x70008000 0x4000>; interrupts = <2>; cd-gpios = <&gpio1 6 0>; wp-gpios = <&gpio1 5 0>; }; }; In above SD example, irq_of_parse_and_map will just work out the SD controller internal irq to tzic. How can we work out the card-detection irq to gpio controller in the same way?
-- Regards, Shawn
|  |