lkml.org 
[lkml]   [2012]   [Dec]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: Sharing PCIE driver between Microblaze and Arm zynq
From
2012/12/7 Grant Likely <grant.likely@secretlab.ca>:
> On Fri, 07 Dec 2012 10:45:01 +0100, Michal Simek <monstr@monstr.eu> wrote:
>> On 12/06/2012 10:27 PM, Bjorn Helgaas wrote:
>> > [+cc linux-pci]
>> >
>> > On Thu, Dec 6, 2012 at 7:23 AM, Michal Simek <michal.simek@xilinx.com> wrote:
>> >> Hi guys,
>> >>
>> >> I have a question regarding to sharing generic OF pcie driver between
>> >> two architectures MB and ARM Zynq.
>> >> Is drivers/pci/pcie location good for it?
>> >> Make no sense to have the same driver in two locations.
>> >
>> > I think you're talking about a PCI host bridge driver. It would
>> > definitely be nice to move toward a generic, shared driver. Host
>> > bridge drivers are responsible for enumerating the PCI hierarchy below
>> > the bridge. Enumeration is not really PCIe-specific, so I wouldn't
>> > put it in drivers/pci/pcie.
>>
>> Not a PCI expert, just trying to find out the proper location for this shared driver.
>>
>>
>> >> Is using readl/writel IO functions in this driver the best option
>> >> which we can have?
>> >> Or is there any other recommendation?
>> >
>> > I'm not really a driver person, but if you're writing a new driver,
>> > wouldn't you use the iomap interfaces (ioremap(), ioread32(), etc)
>> > rather than readl()?
>>
>> That driver exists but it is not in mainline and it is better to directly
>> add it to proper location with correct io functions.
>> The question is if ioread/iowrite functions are correct one.
>> PowerPC io-defs.h suggests that readl/writel should be used for PCI.
>>
>>
>> >> Also just want to check if it is correct to use pcie device_type.
>> >
>> > I don't know what you're asking here. Can you elaborate or give a
>> > specific example?
>>
>> If node property device_type pcie should be used.
>> device_type = "pcie";
>>
>> For pci it is device_type = "pci";
>> For network it is device_type = "network"
>> the same for serial, watchdogs.
>>
>> Do we have any list of device_types which we should use?
>
> Don't use them unless a binding requires it. PCI address lookup code
> uses it, so we put it in those nodes. Otherwise device_type is
> deprecated and has been for a long time now. You should not be using it
> in .dts files.


Thanks,
Michal


--
Michal Simek, Ing. (M.Eng)
w: www.monstr.eu p: +42-0-721842854
Maintainer of Linux kernel 2.6 Microblaze Linux - http://www.monstr.eu/fdt/
Microblaze U-BOOT custodian


\
 
 \ /
  Last update: 2012-12-10 09:21    [W:0.075 / U:0.040 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site