lkml.org 
[lkml]   [2012]   [Oct]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [qla2xxx] INFO: possible irq lock inversion dependency detected
Hi Jiri,

Thanks for taking a look!

> This seems to be real. You should be seeing that since 3.5-rc1 already
> though ... ?
>
> Does the patch below fix that?
>

Yes, it does, thanks! But 3.6-rc kernels were booting fine as far as I remember.
I'll check again and get back tomorrow.

>
> From: Jiri Kosina <jkosina@suse.cz>
> Subject: [PATCH] [SCSI] qla2xxx: fix potential deadlock on ha->hardware_lock
>
> Lockdep reports:
>
> === [ cut here ] ===
> =========================================================
> [ INFO: possible irq lock inversion dependency detected ]
> 3.6.0-0.0.0.28.36b5ec9-default #1 Not tainted
> ---------------------------------------------------------
> qla2xxx_1_dpc/368 just changed the state of lock:
> (&(&ha->vport_slock)->rlock){+.....}, at: [<ffffffffa009b377>] qla2x00_configure_hba+0x197/0x3c0 [qla2xxx]
> but this lock was taken by another, HARDIRQ-safe lock in the past:
> (&(&ha->hardware_lock)->rlock){-.....}
>
> and interrupts could create inverse lock ordering between them.
>
> other info that might help us debug this:
> Possible interrupt unsafe locking scenario:
>
> CPU0 CPU1
> ---- ----
> lock(&(&ha->vport_slock)->rlock);
> local_irq_disable();
> lock(&(&ha->hardware_lock)->rlock);
> lock(&(&ha->vport_slock)->rlock);
> <Interrupt>
> lock(&(&ha->hardware_lock)->rlock);
> === [ cut here ] ===
>
> Fix the potential deadlock by disabling IRQs while holding ha->vport_slock.
>
> Reported-by: Srivatsa S. Bhat <srivatsa.bhat@linux.vnet.ibm.com>
> Signed-off-by: Jiri Kosina <jkosina@suse.cz>

Tested-by: Srivatsa S. Bhat <srivatsa.bhat@linux.vnet.ibm.com>

Regards,
Srivatsa S. Bhat

> ---
> drivers/scsi/qla2xxx/qla_init.c | 5 +++--
> 1 files changed, 3 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/scsi/qla2xxx/qla_init.c b/drivers/scsi/qla2xxx/qla_init.c
> index 799a58b..48fca47 100644
> --- a/drivers/scsi/qla2xxx/qla_init.c
> +++ b/drivers/scsi/qla2xxx/qla_init.c
> @@ -2080,6 +2080,7 @@ qla2x00_configure_hba(scsi_qla_host_t *vha)
> uint8_t domain;
> char connect_type[22];
> struct qla_hw_data *ha = vha->hw;
> + unsigned long flags;
>
> /* Get host addresses. */
> rval = qla2x00_get_adapter_id(vha,
> @@ -2154,9 +2155,9 @@ qla2x00_configure_hba(scsi_qla_host_t *vha)
> vha->d_id.b.area = area;
> vha->d_id.b.al_pa = al_pa;
>
> - spin_lock(&ha->vport_slock);
> + spin_lock_irqsave(&ha->vport_slock, flags);
> qlt_update_vp_map(vha, SET_AL_PA);
> - spin_unlock(&ha->vport_slock);
> + spin_unlock_irqrestore(&ha->vport_slock, flags);
>
> if (!vha->flags.init_done)
> ql_log(ql_log_info, vha, 0x2010,
>



\
 
 \ /
  Last update: 2012-10-04 18:21    [W:0.111 / U:0.052 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site