Messages in this thread | | | From | (Eric W. Biederman) | Date | Mon, 22 Oct 2012 13:43:21 -0700 | Subject | Re: [PATCH v1 2/2] x86, apic: Disable BSP if boot cpu is AP |
| |
"H. Peter Anvin" <hpa@zytor.com> writes:
> On 10/22/2012 01:31 PM, Eric W. Biederman wrote: >>> >>> IIRC Fenghua experimented with that and it didn't work. Not all BIOSes >>> use that bit to determine BSP-ness. >> >> What does a BIOS have to do with anything? >> >> The practical issue here is does an INIT IPI cause the cpu to go into >> startup-ipi-wait or to start booting at 4G-16 bytes. >> >> For dealing with BIOSen we may still need to use the bootstrap processor >> for firmware calls, cpu suspend, and other firmware weirdness, but that >> should all be completely orthogonal to the behavior to what happens >> when an INIT IPI is sent to the cpu. >> >> The only firmware problem I can imagine having is cpu virtualization >> bug. >> > > The whole problem is that some BIOSes go wonky after receiving an INIT > (as in INIT-SIPI-SIPI) to the BSP.
The reason the BIOSen go wonky is the INIT cause the cpu to go to the reset vector at 4G-16 bytes. So it is very much expected that the BIOSen start acting like you just came out of reset.
If you can clear bit 8 of IA32_APIC_BASE_MSR and inform the cpu to not send the cpu to 4G-16 bytes and instead send the cpu into it's magic startup-ipi-wait mode then the BIOSen will not be involved on that path.
It is a simple question of does the cpu support clearing bit 8 meaningfully.
If the cpu allows bit 8 to be cleared and sends the cpu to the reset vector on receipt of the INIT IPI I would call that a deviation from the x86 cpu specification.
So clearing bit 8 is not a question about BIOSen it is a question of can we avoid the BIOSen, by using an obscure under-documented cpu feature.
Eric
| |