lkml.org 
[lkml]   [2012]   [Oct]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [RFT/PATCH] serial: omap: prevent resume if device is not suspended.
Date
Sourav <sourav.poddar@ti.com> writes:

> Hi Paul,
>
> There are
> On Thursday 11 October 2012 11:58 PM, Paul Walmsley wrote:
>> Hi Sourav, Felipe,
>>
>> any progress on fixing the N800 problem? Would be good to keep it booting
>> since we use it as our primary 2420 test platform.
>>
>>
>> - Paul
> The patch sent inlined below might help us to get rid of the serial
> init issue.
> Unfortunately, I dont have a N800 board with me to test it and will require
> your help to do so.
> -----------
> From: Sourav Poddar <sourav.poddar@ti.com>
> Date: Wed, 1 Aug 2012 15:44:12 +0530
> Subject: [RFT/PATCH] serial: omap: Fix N800 serial init issue.
>
>
> This patch might solve the N800 serial init issue.
>
> This patch will also give pointers if there is any mux settings issue
> with N800 OR
> a mismatch between the initial harware state, runtime PM state and
> omap hwmod state.

> I don't have a N800 schematics to check about the mux settings getting used.
>
> The observation on beagle board XM with this patch on different boards
> looks flaky,
> so your feedback on beagle board will also be very helpful.
>
> Cc: Felipe Balbi <balbi@ti.com>
> Signed-off-by: Sourav Poddar <sourav.poddar@ti.com>
> ---
> drivers/tty/serial/omap-serial.c | 1 +
> 1 files changed, 1 insertions(+), 0 deletions(-)
>
> diff --git a/drivers/tty/serial/omap-serial.c
> b/drivers/tty/serial/omap-serial.c
> index 6ede6fd..3fbc7f7 100644
> --- a/drivers/tty/serial/omap-serial.c
> +++ b/drivers/tty/serial/omap-serial.c
> @@ -1414,6 +1414,7 @@ static int __devinit serial_omap_probe(struct
> platform_device *pdev)
> INIT_WORK(&up->qos_work, serial_omap_uart_qos_work);
>
> platform_set_drvdata(pdev, up);
> + pm_runtime_set_active(&pdev->dev);

NAK.

This will obviously break platforms where the UARTs are not active
before driver loads.

Kevin

> pm_runtime_enable(&pdev->dev);
> pm_runtime_use_autosuspend(&pdev->dev);
> pm_runtime_set_autosuspend_delay(&pdev->dev,


\
 
 \ /
  Last update: 2012-10-12 19:22    [W:0.078 / U:0.372 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site