lkml.org 
[lkml]   [2012]   [Jan]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] backlight: lcd: add driver for raster-type lcd's with gpio controlled panel reset
On 01/07/2012 07:23 PM, Russell King - ARM Linux wrote:
> On Thu, Jan 05, 2012 at 09:12:26PM +0530, Thomas Abraham wrote:
>> Add a lcd panel driver for simple raster-type lcd's which uses a gpio
>> controlled panel reset. The driver controls the nRESET line of the panel
>> using a gpio connected from the host system. The Vcc supply to the panel
>> is (optionally) controlled using a voltage regulator. This driver excludes
>> support for lcd panels that use a serial command interface or direct
>> memory mapped IO interface.
>
> I'm trying to work out what kind of LCD panel this is for. I assume
> not the panels which would be connected to a SoC, which have a parallel
> interface to a frame buffer device (LCD controller)?
>
> If this is for these kinds of LCD panels, how are you handling the
> timing required for active panels - some of which must not be powered
> up without the LCD controller first being setup and enabled, and must
> be powered down before the LCD controller is disabled.
>
> I've seen this requirement with panels connected to ARM Ltd's development
> boards, and also some SoCs.

This is handled by the LCD framework. Or at least should be, see this patchset
http://www.spinics.net/lists/linux-fbdev/msg04503.html

- Lars


\
 
 \ /
  Last update: 2012-01-07 19:35    [W:0.094 / U:0.640 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site