lkml.org 
[lkml]   [2012]   [Jan]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    /
    Date
    From
    Subject[ANNOUNCE] sdparm 1.07 available
    sdparm is a command line utility designed to get and set
    SCSI device parameters (cf hdparm for ATA disks). The
    parameters are held in mode pages. Apart from SCSI devices
    (e.g. disks, tapes and enclosures) sdparm can be used on
    any device that uses a SCSI command set. Almost all CD/DVD/BD
    drives use the SCSI MMC set irrespective of the transport.
    sdparm also can decode VPD pages including the device
    identification page. Commands to start and stop the media;
    load and unload removable media and some other housekeeping
    functions are supported. sdparm supports both the Linux
    kernel 2.4 and 2.6 series with ports to FreeBSD, Solaris,
    Tru64 and Windows.

    The version tracks changes in draft standards from
    www.t10.org since October 2010.

    For more information and downloads see:
    http://sg.danny.cz/sg/sdparm.html


    ChangeLog for sdparm-1.07 [20120121] [svn: r188]
    - LB provisioning + Block limits VPD pages to sbc3r27
    - Enhanced phy control page: optical mode enabled (spl-r07)
    - Phy control and discover page: sync to spl2r02
    - sync with spc4r31+32 (handle status good with sense)
    - extended inquiry VPD: add POA_SUP, HRA_SUP and VSA_SUP
    - application tag mode page subcode 0xf0->0x2 (sbc3r28)
    - add 'sinq' pseudo VPD page for standard inquiry response
    - add power consumption mode and VPD pages (spc4r33)
    - point out some mode page numbers are vendor specific

    ChangeLog for sdparm-1.06 [20101031] [svn: r166]
    ...

    Doug Gilbert


    \
     
     \ /
      Last update: 2012-01-22 02:55    [W:0.021 / U:0.100 seconds]
    ©2003-2016 Jasper Spaans. hosted at Digital OceanAdvertise on this site