lkml.org 
[lkml]   [2011]   [Aug]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 7/9 v4] Input: synaptics - process finger (<=3) transitions
On 08/18/2011 04:28 AM, Daniel Kurtz wrote:
> Synaptics image sensor touchpads track 5 fingers, but only report 2.
> This patch attempts to deal with some idiosyncrasies of these touchpads:
>
> * When there are 3 or more fingers, only two are reported.
> * The touchpad tracks the 5 fingers in slot[0] through slot[4].
> * It always reports the lowest and highest valid slots in SGM and AGM
> packets, respectively.
> * The number of fingers is only reported in the SGM packet. However,
> the number of fingers can change either before or after an AGM
> packet.
> * Thus, if an SGM reports a different number of fingers than the last
> SGM, it is impossible to tell whether the intervening AGM corresponds
> to the old number of fingers or the new number of fingers.
> * For example, when going from 2->3 fingers, it is not possible to tell
> whether tell AGM contains slot[1] (old 2nd finger) or slot[2] (new
> 3rd finger).
> * When fingers are added one at at time, from 1->2->3, it is possible to
> track which slots are contained in the SGM and AGM packets:
> 1 finger: SGM = slot[0], no AGM
> 2 fingers: SGM = slot[0], AGM = slot[1]
> 3 fingers: SGM = slot[0], AGM = slot[2]
> * It is also possible to track which slot is contained in the SGM when 1
> of 2 fingers is removed. This is because the touchpad sends a special
> (0,0,0) AGM packet whenever all fingers are removed except slot[0]:
> Last AGM == (0,0,0): SGM contains slot[1]
> Else: SGM contains slot[0]
> * However, once there are 3 fingers, if exactly 1 finger is removed, it
> is impossible to tell which 2 slots are contained in SGM and AGM.
> The (SGM,AGM) could be (0,1), (0,2), or (1,2). There is no way to know.
> * Similarly, if two fingers are simultaneously removed (3->1), then it
> is only possible to know if SGM still contains slot[0].
> * Since it is not possible to reliably track which slot is being
> reported, we invalidate the tracking_id every time the number of
> fingers changes until this ambiguity is resolved when:
> a) All fingers are removed.
> b) 4 or 5 fingers are touched, generates an AGM-CONTACT packet.
> c) All fingers are removed except slot[0]. In this special case, the
> ambiguity is resolved since by the (0,0,0) AGM packet.
>
> Behavior of the driver:
>
> When 2 or more fingers are present on the touchpad, the kernel reports
> up to two MT-B slots containing the position data for two of the fingers
> reported by the touchpad. If the identity of a finger cannot be tracked
> when the number-of-fingers changes, the corresponding MT-B slot will be
> invalidated (track_id set to -1), and a new track_id will be assigned in
> a subsequent input event report.
>
> The driver always reports the total number of fingers using one of the
> EV_KEY/BTN_TOOL_*TAP events. This could differ from the number of valid
> MT-B slots for two reasons:
> a) There are more than 2 fingers on the pad.
> b) During ambiguous number-of-fingers transitions, the correct track_id
> for one or both of the slots cannot be determined, so the slots are
> invalidated.
>
> Thus, this is a hybrid singletouch/MT-B scheme. Userspace can detect
> this behavior by noting that the driver supports more EV_KEY/BTN_TOOL_*TAP
> events than its maximum EV_ABS/ABS_MT_SLOT.
>
> Signed-off-by: Daniel Kurtz <djkurtz@chromium.org>

Acked-by: Chase Douglas <chase.douglas@canonical.com>


\
 
 \ /
  Last update: 2011-08-18 18:05    [W:2.048 / U:1.256 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site