lkml.org 
[lkml]   [2011]   [Jun]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 00/10] mm: Linux VM Infrastructure to support Memory Power Management
* Dave Hansen <dave@linux.vnet.ibm.com> [2011-06-29 10:06:24]:

> I was kinda hoping for something a bit simpler than that. I'd boil down
> what you were saying to this:
>
> 1. The kernel must be aware of how the pieces of hardware are
> mapped in to the system's physical address space
> 2. The kernel must have a mechanism in place to minimize access to
> specific pieces of hardware
(mainly by controlling allocations and reclaim)


> 3. For destructive power-down operations, the kernel should have a
> mechanism in place to ensure that no valuable data is contained
> in the memory to be powered down.
>
> Is that complete?

At a high level these are the main requirements, except that different
operations/features can happen at different/higher granularity. The
infrastructure should be able to related groups of regions and act
upon for a specific optimization. Like granularity for (2) may be
512MB, while (3) could be a pair of 512MB blocks. This is relatively
a minor issue to solve.

> On Wed, 2011-06-29 at 18:30 +0530, Ankita Garg wrote:
> > 1) Dynamic Power Transition: The memory controller can have the ability
> > to automatically transition regions of memory into lower power states
> > when they are devoid of references for a pre-defined threshold amount of
> > time. Memory contents are preserved in the low power states and accessing
> > memory that is at a low power state takes a latency hit.
> >
> > 2) Dynamic Power Off: If a region is free/unallocated, the software can
> > indicate to the controller to completely turn off power to a certain
> > region. Memory contents are lost and hence the software has to be
> > absolutely sure about the usage statistics of the particular region. This
> > is a runtime capability, where the required amount of memory can be
> > powered 'ON' to match the workload demands.
> >
> > 3) Partial Array Self-Refresh (PASR): If a certain regions of memory is
> > free/unallocated, the software can indicate to the controller to not
> > refresh that region when the system goes to suspend-to-ram state and
> > thereby save standby power consumption.
>
> (3) is simply a subset of (2), but with the additional restriction that
> the power off can only occur during a suspend operation.
>
> Let's say we fully implemented support for (2). What would be missing
> to support PASR?

The similarity between (2) and (3) here is the need for accurate
statistics to know allocation status. The difference is the
actuation/trigger part... in case of (2) the trigger would happen
during allocation/free while in case of (3) it happens only at suspend
time. Also the granularity could be different, generally PASR is very
fine grain as compared for power-off at controller level.

We can combine them and look at just how to track allocations at
different (or multiple) physical boundaries.

--Vaidy



\
 
 \ /
  Last update: 2011-06-29 20:11    [W:2.043 / U:0.028 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site