lkml.org 
[lkml]   [2011]   [May]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH 2/2] drm/nouveau: Check that the device is enabled before processing interrupt
From
Date
On Tue, 2011-05-03 at 22:18 -0600, Alex Williamson wrote:
> On Wed, 2011-05-04 at 13:50 +1000, Dave Airlie wrote:
> > On Mon, May 2, 2011 at 10:49 AM, Alex Williamson
> > <alex.williamson@redhat.com> wrote:
> > > We're likely to be sharing an interrupt line with other devices,
> > > which means our handler might get called after we've turned off
> > > the device via vga switcheroo. This can lead to all sorts of
> > > badness, like nv04_fifo_isr() spewing "PFIFO still angry after
> > > 100 spins, halt" to the console before the system enters a hard
> > > hang.
> > >
> > > We can avoid this by simply checking if the device is still
> > > enabled before processing an interrupt. To avoid races, flush
> > > any inflight interrupts using synchronize_irq(). Note that
> > > since pci_intx() is called after pci_save_state(),
> > > pci_restore_state() will automatically re-enable INTx.
> >
> > I still think we should just need the synchronize_irq followed by a
> > check in the irq handler for all fs,
> >
> > or is there a race there I'm missing?
>
> The synchronize_irq by itself doesn't guarantee anything. The irq
> handler could be immediately started on another CPU once that returns
> and be well past the first device read before we make it far enough
> through pci_set_power_state that the device becomes unresponsive. Can
> we guarantee that first device read in the interrupt handler will always
> be 0 or -1 in the suspend path? Even as the last milliamperes of charge
> drain out of the device?

It should always be a valid irq or 0xffffffff. It got nothing to do with
milliamperes of charge, and all to do with the PCI BAR decodes being
turned off.

> By adding the device enabled check in the interrupt handler, disabling
> the device, then calling synchronize_irq, we guarantee that the entire
> interrupt handler path is not being executed and won't be executed again
> until we re-enable the device. It does seem a bit odd, but how many
> other devices in the system are entirely powered off, with a driver
> attached and interrupt handler registered while the system is still
> humming along? Thanks,

The theory is lots. OLPC does this sort of things for its breakfast I'd
have thought.

which is why I still think we are missing something, when we D3 the
device it should be the same as suspend/resume cycle pretty much,

I'll have to think about it a bit more and maybe see what PM guys can
tell us.

mjg59 any clues?

Dave.



\
 
 \ /
  Last update: 2011-05-04 06:25    [W:0.057 / U:0.100 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site