Messages in this thread Patch in this message | | | From | David Decotigny <> | Subject | [PATCH 1/2] forcedeth: make module parameters readable in /sys/module | Date | Wed, 18 May 2011 14:09:59 -0700 |
| |
This change allows to publish the values of the module parameters in /sys/module.
Signed-off-by: David Decotigny <decot@google.com> --- drivers/net/forcedeth.c | 16 ++++++++-------- 1 files changed, 8 insertions(+), 8 deletions(-)
diff --git a/drivers/net/forcedeth.c b/drivers/net/forcedeth.c index 112dc0b..9566567 100644 --- a/drivers/net/forcedeth.c +++ b/drivers/net/forcedeth.c @@ -5990,21 +5990,21 @@ static void __exit exit_nic(void) pci_unregister_driver(&driver); } -module_param(max_interrupt_work, int, 0); +module_param(max_interrupt_work, int, S_IRUGO); MODULE_PARM_DESC(max_interrupt_work, "forcedeth maximum events handled per interrupt"); -module_param(optimization_mode, int, 0); +module_param(optimization_mode, int, S_IRUGO); MODULE_PARM_DESC(optimization_mode, "In throughput mode (0), every tx & rx packet will generate an interrupt. In CPU mode (1), interrupts are controlled by a timer. In dynamic mode (2), the mode toggles between throughput and CPU mode based on network load."); -module_param(poll_interval, int, 0); +module_param(poll_interval, int, S_IRUGO); MODULE_PARM_DESC(poll_interval, "Interval determines how frequent timer interrupt is generated by [(time_in_micro_secs * 100) / (2^10)]. Min is 0 and Max is 65535."); -module_param(msi, int, 0); +module_param(msi, int, S_IRUGO); MODULE_PARM_DESC(msi, "MSI interrupts are enabled by setting to 1 and disabled by setting to 0."); -module_param(msix, int, 0); +module_param(msix, int, S_IRUGO); MODULE_PARM_DESC(msix, "MSIX interrupts are enabled by setting to 1 and disabled by setting to 0."); -module_param(dma_64bit, int, 0); +module_param(dma_64bit, int, S_IRUGO); MODULE_PARM_DESC(dma_64bit, "High DMA is enabled by setting to 1 and disabled by setting to 0."); -module_param(phy_cross, int, 0); +module_param(phy_cross, int, S_IRUGO); MODULE_PARM_DESC(phy_cross, "Phy crossover detection for Realtek 8201 phy is enabled by setting to 1 and disabled by setting to 0."); -module_param(phy_power_down, int, 0); +module_param(phy_power_down, int, S_IRUGO); MODULE_PARM_DESC(phy_power_down, "Power down phy and disable link when interface is down (1), or leave phy powered up (0)."); MODULE_AUTHOR("Manfred Spraul <manfred@colorfullife.com>"); -- 1.7.3.1
| |