lkml.org 
[lkml]   [2011]   [Apr]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    Patch in this message
    /
    From
    Subject[PATCH 3/3] drivers:misc:ti-st: fix skip remote baud logic
    Date
    From: Victor Goldenshtein <victorg@ti.com>

    Texas Instruments WiLink connectivity combo chipsets support custom baud
    rates over its UART interface.
    This can be achieved by sending the change remote baud rate command.
    Since the baud rate can be properly set by the user-space on shared
    transport the remote chip-side and local host-side baud rate is change
    by the User Space Init Manager.

    This patch when encounters the same command inside the firmware,
    attempts to skip such command since it is handled by the user-space.
    The logic to skip the command when it is un-commented is fixed by this
    patch.

    Signed-off-by: Pavan Savoy <pavan_savoy@ti.com>
    Author: Victor Goldenshtein <victorg@ti.com>
    ---
    drivers/misc/ti-st/st_kim.c | 6 ++++--
    1 files changed, 4 insertions(+), 2 deletions(-)

    diff --git a/drivers/misc/ti-st/st_kim.c b/drivers/misc/ti-st/st_kim.c
    index 9ee4c78..b638a7d 100644
    --- a/drivers/misc/ti-st/st_kim.c
    +++ b/drivers/misc/ti-st/st_kim.c
    @@ -244,9 +244,9 @@ void skip_change_remote_baud(unsigned char **ptr, long *len)
    pr_err("invalid action after change remote baud command");
    } else {
    *ptr = *ptr + sizeof(struct bts_action) +
    - ((struct bts_action *)nxt_action)->size;
    + ((struct bts_action *)cur_action)->size;
    *len = *len - (sizeof(struct bts_action) +
    - ((struct bts_action *)nxt_action)->size);
    + ((struct bts_action *)cur_action)->size);
    /* warn user on not commenting these in firmware */
    pr_warn("skipping the wait event of change remote baud");
    }
    @@ -385,6 +385,8 @@ static long download_firmware(struct kim_data_s *kim_gdata)
    }
    /* fw download complete */
    release_firmware(kim_gdata->fw_entry);
    + if (len != 0)
    + pr_err("%s:failed, script not parsed completely", __func__);
    return 0;
    }

    --
    1.7.0.4


    \
     
     \ /
      Last update: 2011-04-08 12:01    [W:0.021 / U:60.784 seconds]
    ©2003-2016 Jasper Spaans. hosted at Digital OceanAdvertise on this site