Messages in this thread | | | Date | Fri, 25 Feb 2011 14:53:08 -0500 | From | Steven Rostedt <> | Subject | Re: Is it a workqueue related issue in 2.6.37 (Was: Re: [libvirt] blkio cgroup [solved]) |
| |
On Fri, Feb 25, 2011 at 08:24:15AM +0100, Dominik Klein wrote: > > Maybe watching what the workqueue is doing using the following trace > > events could be helpful. > > > > # grep workqueue /sys/kernel/debug/tracing/available_events > > workqueue:workqueue_insertion > > workqueue:workqueue_execution > > workqueue:workqueue_creation > > workqueue:workqueue_destruction > > Since I've never done this before, I will tell you how I captured the > trace so you know what I did and can see whether I did something wrong > and can correct me if necessary. > > echo blk > /sys/kernel/debug/tracing/current_tracer > echo 1 > /sys/block/sdb/trace/enable > echo workqueue_queue_work >> /sys/kernel/debug/tracing/set_event > echo workqueue_activate_work >> /sys/kernel/debug/tracing/set_event > echo workqueue_execute_start >> /sys/kernel/debug/tracing/set_event > echo workqueue_execute_end >> /sys/kernel/debug/tracing/set_event > cat /sys/kernel/debug/tracing/trace_pipe
Just an FYI,
If you download trace-cmd from:
git://git.kernel.org/pub/scm/linux/kernel/git/rostedt/trace-cmd.git
You could do the following:
# trace-cmd record -p blk -e workqueue_queue_work -e workqueue_activate_work -e workqueue_execute_start -e workqueue_execute_end <cmd>
Where <cmd> could be sh -c "echo 1 > /sys/block/sdb/trace/enable; sleep 10"
This will create a trace.dat file that you can read with trace-cmd report
Another way, if you want to do more than just that echo is to use:
# trace-cmd start -p blk -e workqueue_queue_work -e workqueue_activate_work -e workqueue_execute_start -e workqueue_execute_end # echo 1 > /sys/block/sdb/trace/enable # <do anyting you want> # trace-cmd stop # trace-cmd extract
The start just enable ftrace (like you did with the echos). The extract will create the trace.dat file from the ftrace ring buffers. You could alse just cat trace_pipe, which would do the same, or you could do the echos, and then the trace-cmd stop and extract to get the file. It's your choice ;)
You can then gzip the trace.dat file and send it to others that can read it as well, as all the information needed to read the trace is recorded in the file.
You could even send the data over the network instead of writing the trace.dat locally.
On another box:
$ trace-cmd listen -p 12345
Then on the target:
# trace-cmd record -N host:12345 ...
This will send the data to the listening host and the file will be created on the host side.
One added benefit of having the trace.dat file. kernelshark can read it.
-- Steve
> > And that output i gzip'd. > > This was taken with 2.6.37 plus the patch you mentioned on a Dell R815 > with 2 12 core AMD Opteron 6174 CPUs. If you need any more information, > please let me know. >
| |