lkml.org 
[lkml]   [2011]   [Dec]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 2/2] Input: tsc2007 - Add a z1_low_threshhold platform data parameter
On Thu, Dec 01, 2011 at 05:04:55PM +0800, Feng Tang wrote:
> Hi Dmitry,
>
>
> On Thu, 1 Dec 2011 16:45:24 +0800
> Dmitry Torokhov <dmitry.torokhov@gmail.com> wrote:
>
>
> > > >
> > > > Even if we add the pressure threshold would not that noise cause
> > > > endless stream of interrupts?
> > >
> > > No, there is no endless interrupts for tsc2007. Without the z1
> > > threshold, the while circle in tsc2007_soft_irq will run endlessly
> > > as the noise data will be seen as a valid data:
> > >
> > > rt = tsc2007_calculate_pressure(ts, &tc);
> > > if (rt == 0 && !ts->get_pendown_state) {
> > > /*
> > > * If pressure reported is 0 and we don't
> > > have
> > > * callback to check pendown state, we have
> > > to
> > > * assume that pen was lifted up.
> > > */
> > > break;
> > > }
> > >
> > > With the z1 threshold check, the rt will be 0 for noise data, and
> > > the code flow broke out.
> >
> > What I meant is with the threshold check we'll break out of the ISR
> > but why won't IRQ be raised again?
>
> The IRQ will be fired again after we exist the tsc2007_soft_irq in my
> test, as I re-enable the irq before existing the code.
>
> >
> > >
> > > >
> > > > Also, what kind of z2 is reported with low z1? And do you
> > > > implement get_pendown_state()?
> > >
> > > z2 seems normal as some data between 3000-4000. We don't have a
> > > get_pendown_state().
> >
> > OK, there is max_rt platform parameter. I think we should employ it
> > instead and break out if we get several incorrect samples in a row.
> > Too bad you do not have a dedicate method.
> >
> No, the max_rt won't help here, if the rt > max_rt, it won't break the
> while loop, but just issue a warning message
>
> if (rt <= ts->max_rt) {
> .......
>
> } else {
> /*
> * Sample found inconsistent by debouncing or pressure is
> * beyond the maximum. Don't report it to user space,
> * repeat at least once more the measurement.
> */
> dev_dbg(&ts->client->dev, "ignored pressure %d\n", rt);
> }

What I meant that we need to ajust the logic to _exit_ the loop if we
receive several samples with rt > max_rt instead of adding a new
parameter.

Thanks.

--
Dmitry


\
 
 \ /
  Last update: 2011-12-04 09:57    [W:0.065 / U:0.220 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site