lkml.org 
[lkml]   [2011]   [Jan]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] musb: move usb_add_hcd to the core init code from gadget code (v2)
Hi,

On Mon, Jan 10, 2011 at 06:47:58AM -0500, Brad Parker wrote:
> I know this is a top post, and a comment on a post from August, but I'd like
> to point out that without this patch I can't get musb host mode to work
> on the beagle board xm (3630).
>
> With this patch, host mode works. If I disconnect and reconnect the port
> goes into "a_idle", which is almost right, and will go into host mode if
> I "echo >/sys/devices/platform/musb_hdrc/mode".
>
> (my expectation is that the mode should toggle from "b_idle" to "a_host"
> when I plug in an a connector with the id pin tied correctly, and
> back to "b_idle"
> when I disconnect)
>
> It seems like few people people test host mode on the omap twl otg port,
> but I have applications which use it...
>
> should this patch get more attention? (there was no response to the
> initial post I could find)

What's the problem in simply insmoding a gadget driver ? If you have OTG
enabled, you _need_ a gadget driver to have a fully working setup. If
you want host only, then change Kconfig.

--
balbi


\
 
 \ /
  Last update: 2011-01-10 12:59    [W:1.193 / U:0.000 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site