lkml.org 
[lkml]   [2010]   [Sep]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: scsi_cmnd data_buffer checksum
Hi Christof,

Thanks for the response.

I am running mkfs.ext3 command.

I am doing the following in the driver for write(10):

Queuecommand:

sg = scsi_sglist(cmd->scsi_cmd);
cmd->write_buf = (u8 *)(kmap_atomic(sg->page, KM_IRQ0) + sg->offset);
Calculate checksum for write_buf

Write Done:
Calculate checksum for cmd->write_buf

and checksums don't match. I am wondering how come OS changed the cmd->write_buf when I have not even unmapped the buffer. Is filesystem changing this cmd->write_buf pages when driver/HW is working on it?

Is there anyway I can avoid this. How about if we allocate a local buffer(kmalloc/pci_alloc_consistent) and memcpy kmap_atomic to that local buffer and then calculate checksum on that local buffer. Will this help?

--Anil

--- On Thu, 9/9/10, Christof Schmitt <christof.schmitt@de.ibm.com> wrote:

> From: Christof Schmitt <christof.schmitt@de.ibm.com>
> Subject: Re: scsi_cmnd data_buffer checksum
> To: "Anil kumar" <anils_r@yahoo.com>
> Cc: linux-kernel@vger.kernel.org, linux-scsi@vger.kernel.org
> Date: Thursday, September 9, 2010, 4:00 AM
> On Wed, Sep 08, 2010 at 08:36:32PM
> -0700, Anil kumar wrote:
> >
> > I am writing a checksum calculation of scsi_cmnd data
> buffer in the driver.
> >
> > I calculate the checksum of the scsi_cmd data
> buffer(request_buffer) in driver queuecommand.
> >
> > Now when the command is completed from the hardware
> and before driver sends it back to mid-layer, I calculate
> the checksum again of the same scsi_cmd data_buffer again.
> >
> > Sometimes the checksums don't match. I mean somehow
> looks like OS changed the scsi_cmd
> data_buffer(request_buffer) in the meantime when driver is
> working on the command.
> > I print the address of the scsi_cmd data_buffer
> (virtual address) and its same and the contents of the
> buffer is also same during both the calculations.
> >
> > Can this happen?
>
> Yes. While a write I/O is being processed in Linux or in
> flight, the
> data buffers can change. This causes problems for other
> checksums as
> well; i ran into this when looking at the DIF/DIX checksums
> for SCSI
> commands.
>
> At the moment, this problem can be avoided e.g. by running
> only direct
> I/O on the xfs filesystem. There have been discussions
> about this, a
> short summary is here, look for "stable pages":
> http://lwn.net/Articles/399148/
>
> Christof
>





\
 
 \ /
  Last update: 2010-09-09 10:37    [W:0.033 / U:2.128 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site