lkml.org 
[lkml]   [2010]   [Sep]   [17]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: PATA IDE is slower in newer versions of kernel
El Thu, 16 Sep 2010 17:30:51 -0600
"Joshua Hintze" <joshh@imsar.com> escribió:

[ Just CC linux-ide ]

> Hello,
>
> I've been digging into this for a couple weeks now. I have an embedded board
> that runs Linux Kernel 2.6.10 that is connected to a SSD over a PATA
> connection. Data is transferred using UDMA4 speeds and I get a nice
> sustained write speed of about 20 MBps which is adequate for us.
>
> I have recently taken the plunge to update to a newer version of the kernel
> starting at 2.6.32 (also tried 2.6.33) and what I am seeing writes speeds
> drop to about 18 MBps peak with large jumps going from 8 MBps->16 MBs for
> sustained throughput.
>
> I decided to read up on the ATA specification and I connected a logic
> analyzer to the PATA bus and here is what is happening...after a large chunk
> of data is written to the device, instead of the device pausing the transfer
> by asserting DDMARDY it actual initiates a device data-out termination by
> pulling DMARQ low.
>
> The old kernel 2.6.10 responds to this by strobing the STOP line 8 times
> within 800uS and the device releases DMARQ shortly afterwards. On the newer
> kernels the strobing of the STOP line takes near 8mS of time. Since the hard
> drive only release DMARQ after this 8 pulse strobe I believe this is the
> cause of the slower write speeds on the newer kernels. This whole process
> happens thousands of times when writing megs of data. So those extra 7mS
> begin to add up fast.
>
> My problem is I've been digging through the ide.c/ide-dma.c and other code
> but I'm not exactly sure where the code would jump to upon a device
> initiated termination on a data-out dma transfer.
>
> My guess is ide_dma_intr(...). Is this correct?
>
> Any other areas I could look at?
>
> Thanks in advance.
>
>
> --
> To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
> the body of a message to majordomo@vger.kernel.org
> More majordomo info at http://vger.kernel.org/majordomo-info.html
> Please read the FAQ at http://www.tux.org/lkml/
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2010-09-17 15:49    [W:0.094 / U:0.200 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site