[lkml]   [2010]   [Sep]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
    SubjectRe: [PATCH 0/8] [Resend] ideapad: using EC command to control rf/camera power
    On Wed, Sep 15, 2010 at 06:13:43PM +0800, Ike Panhc wrote:
    > On 09/10/2010 03:11 PM, Mario 'BitKoenig' Holbe wrote:
    > > rfkill_init_sw_state(priv->rfk[dev], 0);
    > eh.. after review the code, the rfkill_init_sw_state shall not give 0 as the default
    > value. I shall read the value from EC and set reasonable value.

    Well - probably :)
    The current behaviour results in each device becoming unblocked no
    matter what state it had before.

    > > if (no_bt_rfkill && (ideapad_rfk_data[dev].type == RFKILL_TYPE_BLUETOOTH))
    > > ideapad_rfk_set(???, 0);
    > Do you mean driver still setup the rfkill for bluetooth, but we can not block
    > bluetooth when module parameter set to 1? This idea is better then no_bt_rfkill.
    > Will modify the driver.

    Well, not really... I mean: in the no_bt_rfkill=1 case the driver should
    (try to) unblock the bluetooth device in order to activate it to make it
    further manageable via it's own (hci) rfkill switch.
    I don't think setting up the ideapad_bluetooth rfkill is necessary for
    that. Not setting it up is IMHO the right direction. Just the device
    activation is missing.

    Tower: "Say fuelstate." Pilot: "Fuelstate."
    Tower: "Say again." Pilot: "Again."
    Tower: "Arghl, give me your fuel!" Pilot: "Sorry, need it by myself..."
    [unhandled content-type:application/pgp-signature]
     \ /
      Last update: 2010-09-15 13:53    [W:0.026 / U:226.828 seconds]
    ©2003-2016 Jasper Spaans. hosted at Digital OceanAdvertise on this site