lkml.org 
[lkml]   [2009]   [Aug]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    /
    Date
    From
    SubjectRe: [patch] document flash/RAID dangers
    On Tue 2009-08-25 15:33:08, david@lang.hm wrote:
    > On Wed, 26 Aug 2009, Pavel Machek wrote:
    >
    >>> It seems that you are really hung up on whether or not the filesystem
    >>> metadata is consistent after a power failure, when I'd argue that the
    >>> problem with using storage devices that don't have good powerfail
    >>> properties have much bigger problems (such as the potential for silent
    >>> data corruption, or even if fsck will fix a trashed inode table with
    >>> ext2, massive data loss). So instead of your suggested patch, it
    >>> might be better simply to have a file in Documentation/filesystems
    >>> that states something along the lines of:
    >>>
    >>> "There are storage devices that high highly undesirable properties
    >>> when they are disconnected or suffer power failures while writes are
    >>> in progress; such devices include flash devices and software RAID 5/6
    >>> arrays without journals,
    >
    > is it under all conditions, or only when you have already lost redundancy?

    I'd prefer not to specify.

    > prior discussions make me think this was only if the redundancy is
    > already lost.

    I'm not so sure now.

    Lets say you are writing to the (healthy) RAID5 and have a powerfail.

    So now data blocks do not correspond to the parity block. You don't
    yet have the corruption, but you already have a problem.

    If you get a disk failing at this point, you'll get corruption.

    > also, the talk about software RAID 5/6 arrays without journals will be
    > confusing (after all, if you are using ext3/XFS/etc you are using a
    > journal, aren't you?)

    Slightly confusing, yes. Should I just say "MD RAID 5" and avoid
    talking about hardware RAID arrays, where that's really
    manufacturer-specific?

    > in addition, even with a single drive you will loose some data on power
    > loss (unless you do sync mounts with disabled write caches), full data
    > journaling can help protect you from this, but the default journaling
    > just protects the metadata.

    "Data loss" here means "damaging data that were already fsynced". That
    will not happen on single disk (with barriers on etc), but will happen
    on RAID5 and flash.
    Pavel
    --
    (english) http://www.livejournal.com/~pavelmachek
    (cesky, pictures) http://atrey.karlin.mff.cuni.cz/~pavel/picture/horses/blog.html


    \
     
     \ /
      Last update: 2009-08-26 00:43    [W:2.196 / U:0.492 seconds]
    ©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site