lkml.org 
[lkml]   [2009]   [Jun]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH][Updated] New AT91 MCI Driver that supports both MCI slots used at the same time
Rob Emanuele wrote:
> This driver is a port the Atmel AVR32 MCI driver which uses similar silicon.

While I do understand the motivation for this patch, I was kind of
hoping we could reduce the number of drivers for the Atmel MCI
hardware, not increase it...

So I think it would be much better if your changes were integrated into
one of the existing drivers.

> Joey Oravec has mentioned that he has had better reliability with the chip
> he is using (AT91SAM9261) if the MMC controller is reset before each
> command. There is a compile time option to do just that.

This could be a useful option for atmel-mci too.

> Joey Oravec has stated that the Read and Write Proof functionality that
> prevents buffer overflows is not available on the AT91SAM9261. This was
> confirmed by Nicolas Ferre and also affects the AT91RM9200. This new
> patch excludes those register config bits.

Preferably use the cpu_is_xxx() functions to achieve that. Perhaps even
wrap those tests inside a mci_has_xxproof() function to make it
clearer what you're testing for, and easier to change if we decide to
do the test based on version registers, etc. later.

Haavard


\
 
 \ /
  Last update: 2009-06-08 12:51    [W:0.053 / U:1.400 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site