lkml.org 
[lkml]   [2009]   [Jun]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [2.6.31-rc1] iwlagn (4965): regression when hardware rf switch is used
Date
On Monday 29 June 2009, Johannes Berg wrote:
> > [enable]
> > usb 3-1: new full speed USB device using uhci_hcd and address 3
> > usb 3-1: configuration #1 chosen from 1 choice
>
> That is completely unrelated. You plugged in a USB device too :)

No, it's my "bluetooth + wlan" device. Note that disabling wireless with
the hardware switch also gives 'usb 3-1: USB disconnect, address 2'.

From lsusb:
Bus 003 Device 002: ID 03f0:171d Hewlett-Packard Wireless (Bluetooth +
WLAN) Interface [Integrated Module]

> > A lot uglier with those errors. And after that I have to run
> > ifdown/ifup before networking is up again (ifup only does not work as
> > it will complain "interface already configured"):
>
> And that's actually expected, and/or a bug in the debian networking
> scripts.
> (You can trigger the same problem by doing
> ifup wlan0
> ip link set wlan0 down
> ifup wlan0 -> error)

OK, I can accept that. Wonder why it does work with 2.6.30 then. But it
can certainly wait until the driver problem you mentioned is resolved.

> To get your network connection back automatically we will require
> changes to userland tools to listen to rfkill events.
>
> > BTW, would it make sense to bring back the first two lines shown with
> > .30 (or at least the first one):
> > iwlagn 0000:10:00.0: Radio Frequency Kill Switch is On:
> > Kill switch must be turned off for wireless networking to work.
> > IMHO it's good to register the reason for the disconnect.
>
> I guess something like that could be added to cfg80211:
> phy0: taking interfaces down due to rfkill

Yes, that would be nice.

Thanks,
FJP


\
 
 \ /
  Last update: 2009-06-29 11:53    [W:0.132 / U:0.140 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site