lkml.org 
[lkml]   [2009]   [Jun]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [RFC][PATCH] mm: stop balance_dirty_pages doing too much work
On Thu, Jun 25 2009, Al Boldi wrote:
> Jens Axboe wrote:
> > On Thu, Jun 25 2009, Al Boldi wrote:
> > > Jens Axboe wrote:
> > > > On Thu, Jun 25 2009, Jens Axboe wrote:
> > > > > On Thu, Jun 25 2009, Peter Zijlstra wrote:
> > > > > > On Wed, 2009-06-24 at 15:27 -0700, Andrew Morton wrote:
> > > > > > > On Wed, 24 Jun 2009 11:38:24 +0100
> > > > > > >
> > > > > > > Richard Kennedy <richard@rsk.demon.co.uk> wrote:
> > > > > > > > When writing to 2 (or more) devices at the same time, stop
> > > > > > > > balance_dirty_pages moving dirty pages to writeback when it has
> > > > > > > > reached the bdi threshold. This prevents balance_dirty_pages
> > > > > > > > overshooting its limits and moving all dirty pages to
> > > > > > > > writeback.
> > > > > > > >
> > > > > > > >
> > > > > > > > Signed-off-by: Richard Kennedy <richard@rsk.demon.co.uk>
> > > > > > > > ---
> > > > > >
> > > > > > Acked-by: Peter Zijlstra <a.p.zijlstra@chello.nl>
> > > > >
> > > > > After doing some integration and update work on the writeback branch,
> > > > > I threw 2.6.31-rc1, 2.6.31-rc1+patch, 2.6.31-rc1+writeback into the
> > > > > test mix. The writeback series include this patch as a prep patch.
> > > > > Results for the mmap write test case:
> > > > >
> > > > > Kernel Throughput usr sys ctx util
> > > > > --------------------------------------------------------------
> > > > > vanilla 184MB/sec 19.51% 50.49% 12995 82.88%
> > > > > vanilla 184MB/sec 19.60% 50.77% 12846 83.47%
> > > > > vanilla 182MB/sec 19.25% 51.18% 14692 82.76%
> > > > > vanilla+patch 169MB/sec 18.08% 43.61% 9507 76.38%
> > > > > vanilla+patch 170MB/sec 18.37% 43.46% 10275 76.62%
> > > > > vanilla+patch 165MB/sec 17.59% 42.06% 10165 74.39%
> > > > > writeback 215MB/sec 22.69% 53.23% 4085 92.32%
> > > > > writeback 214MB/sec 24.31% 52.90% 4495 92.40%
> > > > > writeback 208MB/sec 23.14% 52.12% 4067 91.68%
> > > > >
> > > > > To be perfectly clear:
> > > > >
> > > > > vanilla 2.6.31-rc1 stock
> > > > > vanilla+patch 2.6.31-rc1 + bdi_thresh patch
> > > > > writeback 2.6.31-rc1 + bdi_thresh patch + writeback series
> > > > >
> > > > > This is just a single spindle w/ext4, nothing fancy. I'll do a
> > > > > 3-series run with the writeback and this patch backed out, to see if
> > > > > it makes a difference here. I didn't do that initially, since the
> > > > > results were in the range that I expected.
> > > >
> > > > Results for writeback without the bdi_thresh patch
> > > >
> > > > Kernel Throughput usr sys ctx util
> > > > --------------------------------------------------------------
> > > > wb-bdi_thresh 211MB/sec 22.71% 53.30% 4050 91.19%
> > > > wb-bdi_thresh 212MB/sec 22.78% 53.55% 4809 91.51%
> > > > wb-bdi_thresh 212MB/sec 22.99% 54.23% 4715 93.10%
> > > >
> > > > Not a lot of difference there, without more than three runs it's hard
> > > > to say what is significant. Could be a small decrease in throughput, if
> > > > the 208MB/sec results from above is an outlier (I think it is,
> > > > ~215MB/sec is usually the most consistent result).
> > >
> > > What's the iowait on these runs?
> >
> > Not sure, I didn't check. Why do you ask?
>
> iowait gives you an indication of seekactivity.

The test case is random mmap writes to files that have been laid out
sequentially. So it's all seeks. The target drive is an SSD disk though,
so it doesn't matter a whole lot (it's a good SSD).

--
Jens Axboe



\
 
 \ /
  Last update: 2009-06-25 16:47    [W:0.102 / U:0.504 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site