Messages in this thread Patch in this message | | | From | Mike Frysinger <> | Subject | [PATCH 10/11] Blackfin Serial Driver: handle anomaly 05000231 | Date | Tue, 2 Jun 2009 03:11:39 -0400 |
| |
From: Sonic Zhang <sonic.zhang@analog.com>
05000231 - UART STB Bit Incorrectly Affects Receiver Setting For processors affected by this, we cannot safely allow CSTOPB to be set as the UART will then be unable to properly clock in bytes.
Signed-off-by: Sonic Zhang <sonic.zhang@analog.com> Signed-off-by: Mike Frysinger <vapier@gentoo.org> --- drivers/serial/bfin_5xx.c | 12 ++++++++++-- 1 files changed, 10 insertions(+), 2 deletions(-)
diff --git a/drivers/serial/bfin_5xx.c b/drivers/serial/bfin_5xx.c index ab583ef..64603f5 100644 --- a/drivers/serial/bfin_5xx.c +++ b/drivers/serial/bfin_5xx.c @@ -828,8 +828,16 @@ bfin_serial_set_termios(struct uart_port *port, struct ktermios *termios, __func__); } - if (termios->c_cflag & CSTOPB) - lcr |= STB; + /* Anomaly notes: + * 05000231 - STOP bit is always set to 1 whatever the user is set. + */ + if (termios->c_cflag & CSTOPB) { + if (ANOMALY_05000231) + printk(KERN_WARNING "STOP bits other than 1 is not " + "supported in case of anomaly 05000231.\n"); + else + lcr |= STB; + } if (termios->c_cflag & PARENB) lcr |= PEN; if (!(termios->c_cflag & PARODD)) -- 1.6.3.1
| |