lkml.org 
[lkml]   [2009]   [Apr]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: Quick question about libata and hdparm
> Can you comment on the dmesg log attached? I'd like to, at least,
> understand what is happening, since I'm starting to consider using
> libata with all my computers.

Its logging a couple of transmission errors. The CRC is computed by
hardware each end and compared (by hardware).

> This computer, in particular, uses an IDE drive with a 40 ribbon cable
> (and, thus, no UDMA/66). The cable is well put (checked two times
> already) and I believe that everything is OK with this cable, since I
> substituted it was already substituting one that gave me the same
> results.

It's tuned down to UDMA33 which looks correct.

If I saw a lot of these I'd suspect something like a controller timing
setup error, but you seem to just have occasional ones in the log which
really does look like genuine CRC errors from electrical noise or similar.

You don't happen to have any amateur radio transmitters or telsa coils in
the room with it ;) ?


\
 
 \ /
  Last update: 2009-04-20 20:45    [W:0.158 / U:0.016 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site