lkml.org 
[lkml]   [2009]   [Apr]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: Spontaneous reboots since 2.6.29-rc*
From
On Fri, Apr 17, 2009 at 10:03 AM, Maciej Rutecki
<maciej.rutecki@gmail.com> wrote:
> Sometimes I observed spontaneous reboots during booting kernel, after
> this message:
> [...]
> [    0.024996] ... PM-Timer delta = 357949
> [    0.024996] ... PM-Timer result ok
> [    0.024996] ..... delta 1249983
> [    0.024996] ..... mult: 53694522
> [    0.024996] ..... calibration result: 199997
> [    0.024996] ..... CPU clock speed is 1999.0972 MHz.
> [    0.024996] ..... host bus clock speed is 199.0997 MHz.
> [    0.024996] Booting processor 1 APIC 0x1 ip 0x6000
>
> after this should be:
> [    0.000999] Initializing CPU#1
> [    0.000999] masked ExtINT on CPU#1
> [    0.000999] Calibrating delay using timer specific routine..
> 4067.56 BogoMIPS (lpj=2033784)
> [    0.000999] CPU: L1 I cache: 32K, L1 D cache: 32K
> [    0.000999] CPU: L2 cache: 1024K
>
>
> Also I found this message in dmesg:
> [    0.000000] 4 Processors exceeds NR_CPUS limit of 2
> [    0.000000] SMP: Allowing 2 CPUs, 0 hotplug CPUs

your config has
CONFIG_NR_CPUS=2

ACPI MADT said:
[ 0.000000] ACPI: LAPIC (acpi_id[0x00] lapic_id[0x00] enabled)
[ 0.000000] ACPI: LAPIC (acpi_id[0x01] lapic_id[0x01] enabled)
[ 0.000000] ACPI: LAPIC (acpi_id[0x02] lapic_id[0x02] disabled)
[ 0.000000] ACPI: LAPIC (acpi_id[0x03] lapic_id[0x03] disabled)

so it should be ok

but the MTRR looks weird...

[ 0.000000] BIOS-provided physical RAM map:
[ 0.000000] BIOS-e820: 0000000000000000 - 000000000009f800 (usable)
[ 0.000000] BIOS-e820: 000000000009f800 - 00000000000a0000 (reserved)
[ 0.000000] BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
[ 0.000000] BIOS-e820: 0000000000100000 - 00000000bf5e0000 (usable)
[ 0.000000] BIOS-e820: 00000000bf5e0000 - 00000000bf5e3000 (ACPI NVS)
[ 0.000000] BIOS-e820: 00000000bf5e3000 - 00000000bf5f0000 (ACPI data)
[ 0.000000] BIOS-e820: 00000000bf5f0000 - 00000000bf600000 (reserved)
[ 0.000000] BIOS-e820: 00000000c0000000 - 00000000d0000000 (reserved)
[ 0.000000] BIOS-e820: 00000000fec00000 - 0000000100000000 (reserved)
[ 0.000000] DMI 2.4 present.
[ 0.000000] last_pfn = 0xbf5e0 max_arch_pfn = 0x100000
[ 0.000000] MTRR default type: uncachable
[ 0.000000] MTRR fixed ranges enabled:
[ 0.000000] 00000-9FFFF write-back
[ 0.000000] A0000-BFFFF uncachable
[ 0.000000] C0000-CAFFF write-protect
[ 0.000000] CB000-EFFFF uncachable
[ 0.000000] F0000-FFFFF write-through
[ 0.000000] MTRR variable ranges enabled:
[ 0.000000] 0 base 000000000 mask F00000000 write-back
[ 0.000000] 1 base 0C0000000 mask FC0000000 uncachable
[ 0.000000] 2 base 0BF800000 mask FFF800000 uncachable
[ 0.000000] 3 base 0BF700000 mask FFFF00000 uncachable
[ 0.000000] 4 base 0BF600000 mask FFFF00000 uncachable
[ 0.000000] 5 disabled
[ 0.000000] 6 disabled
[ 0.000000] 7 disabled

[ 17.421843] [drm] Initialized drm 1.1.0 20060810
[ 17.431172] pci 0000:00:02.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16
[ 17.431179] pci 0000:00:02.0: setting latency timer to 64
[ 17.433356] mtrr: type mismatch for d0000000,10000000 old:
write-back new: write-combining
[ 17.433360] [drm] MTRR allocation failed. Graphics performance may suffer.
[ 17.433388] pci 0000:00:02.0: irq 27 for MSI/MSI-X
[ 17.433409] [drm] Initialized i915 1.6.0 20080730 for 0000:00:02.0 on minor 0
[ 17.452114] mtrr: type mismatch for d0000000,10000000 old:
write-back new: write-combining
[ 17.749084] set status page addr 0x00043000

maybe you could enable
CONFIG_MTRR_SANITIZER=y
CONFIG_MTRR_SANITIZER_ENABLE_DEFAULT=1
CONFIG_MTRR_SANITIZER_SPARE_REG_NR_DEFAULT=1

YH
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2009-04-20 07:19    [W:0.052 / U:0.380 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site