Messages in this thread | | | Date | Thu, 12 Feb 2009 05:08:30 +0100 | From | Frederic Weisbecker <> | Subject | Re: [PATCH 0/7][RFC] function graph tracer port to PowerPC |
| |
On Wed, Feb 11, 2009 at 09:16:57PM -0500, Steven Rostedt wrote: > > On Thu, 12 Feb 2009, Frederic Weisbecker wrote: > > > On Wed, Feb 11, 2009 at 08:10:51PM -0500, Steven Rostedt wrote: > > > > > > The following set of patches are RFC and not for inclusion > > > (unless everyone is fine with them as is). > > > > > > This is the port to PowerPC of the function graph tracer that was written > > > by Frederic Weisbecker for the x86 architecture. It is broken up > > > into a series of logical steps. > > > > > > 1) get generic code ready for other archs > > > 2) get PowerPC 64-bit working with just static function tracing > > > 3) get PowerPC 64-bit working with dynamic function tracing > > > 4) get PowerPC 32-bit working with just static function tracing > > > 5) get PowerPC 32-bit working with dynamic function tracing > > > > > > (with some clean ups in between) > > > > > > > > > Thanks a lot Steven! > > I'm sad to not having a Power Pc to test it... > > If you had a PowerPC, I doubt I would have been the one to port it ;-)
Especially since you already implemented ftrace on PowerPc :) I will acquire an Arm board soon to adapt function graph on Arm...
> -- Steve >
| |