lkml.org 
[lkml]   [2009]   [Dec]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
Subject2.6.33.rc1-git3 - regression in rt61pci driver
From
Hi,

I'm not subscribed, so please cc me on any reply.

I've built and installed today's -git kernel
(v2.6.33-rc1-225-gc9f937e) and find that my (rt61pci) wireless card no
longer works. All the usual drivers are loaded when I insert the card.
The card works fine with 2.6.32.2 (as long as I disable power saving).

The symptoms are that:

1. The file /proc/net/wireless never appears

2. iwconfig gives "wlan0 no wireless extensions."

3. ifconfig wlan0 up succeeds

4. iwconfig wlan0 essid MYSSID gives

Cannot read /proc/net/wireless
Error for wireless request "Set ESSID" (8B1A) :
SET failed on device wlan0 ; Invalid argument.

5. ifconfig -a gives:

wlan0 Link encap:Ethernet HWaddr 00:11:50:DE:04:F4
BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)

6. /proc/net/dev contains:

Inter- | Receive
| Transmit
face |bytes packets errs drop fifo frame compressed
multicast|bytes packets errs drop fifo colls carrier compressed
lo: 600 12 0 0 0 0 0 0
600 12 0 0 0 0 0 0
wlan0: 0 0 0 0 0 0 0 0
0 0 0 0 0 0 0 0

7. dmesg shows the following messages triggered by insertion of the card:

pcmcia_socket pcmcia_socket0: pccard: CardBus card inserted into slot 0
pci 0000:03:00.0: reg 10: [mem 0xffff8000-0xffffffff]
pci 0000:03:00.0: BAR 0: assigned [mem 0xf4000000-0xf4007fff]
pci 0000:03:00.0: BAR 0: set to [mem 0xf4000000-0xf4007fff] (PCI
address [0xf4000000-0xf4007fff]
cfg80211: Calling CRDA to update world regulatory domain
cfg80211: World regulatory domain updated:
(start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
(2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
(2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
(2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
(5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
(5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
rt61pci 0000:03:00.0: enabling device (0000 -> 0002)
rt61pci 0000:03:00.0: PCI INT A -> Link[LNKD] -> GSI 11 (level, low) -> IRQ 11
rt61pci 0000:03:00.0: setting latency timer to 64
phy0: Selected rate control algorithm 'minstrel'
Registered led device: rt61pci-phy0::radio
Registered led device: rt61pci-phy0::assoc


I'll see if I can find time for a bisect session tomorrow, but let me
know if I can supply any additional diagnostics.

Thanks

Chris

--
No, Sir; there is nothing which has yet been contrived by man, by which
so much happiness is produced as by a good tavern or inn - Doctor Samuel
Johnson


\
 
 \ /
  Last update: 2009-12-23 23:51    [W:0.069 / U:0.184 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site