lkml.org 
[lkml]   [2009]   [Dec]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    /
    Date
    From
    SubjectRe: [PATCH] libata: pata_bf54x: handle portmuxing of pins through GPIO PORTs
    On 07/14/2009 01:39 PM, Mike Frysinger wrote:
    > From: Sonic Zhang<sonic.zhang@analog.com>
    >
    > By default, the PATA pins are routed to the async address lines in which
    > case, no peripheral muxing needs to be done. However, if the pins get
    > routed through the GPIO PORTs pins, we need to make sure to request them
    > so that the muxing is properly set up.
    >
    > Signed-off-by: Sonic Zhang<sonic.zhang@analog.com>
    > Signed-off-by: Bryan Wu<cooloney@kernel.org>
    > Signed-off-by: Mike Frysinger<vapier@gentoo.org>
    > ---
    > Andrew: could you pick this up ? it was posted over a month ago to the
    > Linux/IDE list w/no feedback.
    >
    > drivers/ata/pata_bf54x.c | 19 +++++++++++++++++++
    > 1 files changed, 19 insertions(+), 0 deletions(-)


    Added to the tip of libata-dev...

    Linus, if you pull

    master.kernel.org:/pub/scm/linux/kernel/git/jgarzik/libata-dev.git
    upstream-linus

    then you will receive the previous pull (two pata_cmd64x fixes), plus
    the above fix to pata_bf54x.



    \
     
     \ /
      Last update: 2009-12-21 20:01    [W:0.026 / U:29.212 seconds]
    ©2003-2016 Jasper Spaans. hosted at Digital OceanAdvertise on this site