[lkml]   [2009]   [Oct]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
    SubjectRe: [PATCH] mm: make VM_MAX_READAHEAD configurable
    On Fri, 2009-10-09 at 13:19 +0200, Ehrhardt Christian wrote:
    > From: Christian Ehrhardt <>
    > On one hand the define VM_MAX_READAHEAD in include/linux/mm.h is just a default
    > and can be configured per block device queue.
    > On the other hand a lot of admins do not use it, therefore it is reasonable to
    > set a wise default.
    > This path allows to configure the value via Kconfig mechanisms and therefore
    > allow the assignment of different defaults dependent on other Kconfig symbols.
    > Using this, the patch increases the default max readahead for s390 improving
    > sequential throughput in a lot of scenarios with almost no drawbacks (only
    > theoretical workloads with a lot concurrent sequential read patterns on a very
    > low memory system suffer due to page cache trashing as expected).

    Why can't this be solved in userspace?

    Also, can't we simply raise this number if appropriate? Wu did some
    read-ahead trashing detection bits a long while back which should scale
    the read-ahead window back when we're low on memory, not sure that ever
    made it in, but that sounds like a better option than having different
    magic numbers for each platform.

     \ /
      Last update: 2009-10-09 14:27    [W:0.047 / U:9.500 seconds]
    ©2003-2017 Jasper Spaans. hosted at Digital OceanAdvertise on this site